Skip to content

IGCSE Physics · November 2022 · Paper 51 · Difficulty 3 · Standard

Question 3

3

In this experiment, you will investigate the effect of the starting temperature on the cooling rate of water.

Carry out the following instructions, referring to Fig. 3.1.

(a)

Use the thermometer to measure the room temperature $\theta_{\text{R}}$.

$\theta_{\text{R}} =$ °C[1]

(b)

Pour $200\text{ cm}^3$ of hot water into the beaker. Place the thermometer in the hot water.

Record in Table 3.1 the temperature $\theta$ of the hot water at time $t = 0$. Immediately start the stop-watch.

Measure, and record in Table 3.1, the water temperature every $30\text{ s}$ until you have seven sets of readings.[2]

Table 3.1

$t / \text{s}$$\theta / \text{°C}$
0
30
60
90
120
150
180
(c)

Calculate the decrease in temperature $\Delta\theta_1$ between $t = 0$ and $t = 180\text{ s}$.

$\Delta\theta_1 =$

Calculate the average rate of cooling $C_1$ of the water using the equation $C_1 = \frac{\Delta\theta_1}{\Delta t}$,

where $\Delta t = 180\text{ s}$.

$C_1 =$ [1]

(d)

Empty the beaker.

(i)

Using Table 3.1, write down the temperature $\theta_{90}$ of the water at time $t = 90\text{ s}$.

$\theta_{90} =$

Pour $150\text{ cm}^3$ of hot water into the beaker. Place the thermometer in the water. Slowly add cold water, stirring continuously, until the temperature of the water in the beaker is as close as possible to $\theta_{90}$. Record this temperature in Table 3.2 at time $t = 0$.

Immediately start the stop-watch.

Measure, and record in Table 3.2, the water temperature every $30\text{ s}$ until you have four sets of readings.

Table 3.2

$t / \text{s}$$\theta / \text{°C}$
0
30
60
90

[2]

(ii)

Using Table 3.2, calculate the decrease in temperature $\Delta\theta_2$ between $t = 0$ and $t = 90\text{ s}$.

$\Delta\theta_2 =$

Calculate the average rate of cooling $C_2$ of the water using the equation $C_2 = \frac{\Delta\theta_2}{\Delta t}$,

where $\Delta t = 90\text{ s}$.

$C_2 =$ [1]

(e)

A student suggests that the rate of cooling of water depends on the initial temperature of the water.

Write a conclusion about the effect of the initial temperature of water on the rate of cooling of the water, based on your results. Justify your conclusion by reference to values from your results.

conclusion

justification [2]

(f)

State two requirements when reading the volume of water in the measuring cylinder in order to obtain an accurate result.

[2]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

3(a)

  • Leave the thermometer in the room air, away from the hot water, and wait until its reading is steady. This lets it reach room temperature.
  • Read the thermometer at eye level and record $\theta_R$ in $\mathrm{^{\circ}C}$. The drawing has no temperature scale, so the value must come from the thermometer in the room.

3(b)

  • Record the temperature at $t = 0\,\mathrm{s}$ and every $30\,\mathrm{s}$ after that, up to $180\,\mathrm{s}$. The temperatures should decrease as the water cools.
  • Read each temperature to the nearest $1\,{}^{\circ}\mathrm{C}$ or better.

3(c)

  • Use $\Delta\theta_1 = \theta_0 - \theta_{180}$ and $C_1 = \Delta\theta_1/\Delta t$.
  • For example, if the water cools from $80\,{}^{\circ}\mathrm{C}$ to $71\,{}^{\circ}\mathrm{C}$, then $\Delta\theta_1 = 80\,{}^{\circ}\mathrm{C} - 71\,{}^{\circ}\mathrm{C} = \mathbf{9}\,{}^{\circ}\mathrm{C}$.
  • For these example readings, $C_1 = (9\,{}^{\circ}\mathrm{C})/(180\,\mathrm{s}) = \mathbf{0.05}\,{}^{\circ}\mathrm{C/s}$. Use your own temperatures.

3(d)(i)

  • Copy the temperature at $90\,\mathrm{s}$ from Table 3.1 as $\theta_{90}$.
  • Start Table 3.2 at a temperature within $2\,{}^{\circ}\mathrm{C}$ of $\theta_{90}$. Record temperatures every $30\,\mathrm{s}$ to $90\,\mathrm{s}$; they should decrease overall.

3(d)(ii)

  • Use $\Delta\theta_2 = \theta_0 - \theta_{90}$ for Table 3.2, and $C_2 = \Delta\theta_2/\Delta t$.
  • For example, if the water cools from $70\,{}^{\circ}\mathrm{C}$ to $67\,{}^{\circ}\mathrm{C}$, then $\Delta\theta_2 = 70\,{}^{\circ}\mathrm{C} - 67\,{}^{\circ}\mathrm{C} = \mathbf{3}\,{}^{\circ}\mathrm{C}$.
  • For these example readings, $C_2 = (3\,{}^{\circ}\mathrm{C})/(90\,\mathrm{s}) = \mathbf{0.033}\,{}^{\circ}\mathrm{C/s}$. Use your own temperatures.

3(e)

  • Compare your values of $C_1$ and $C_2$. If $C_1$ is larger, the water cooled faster when its starting temperature was higher.
  • Quote both cooling rates with units to support your conclusion. If your results show a different pattern, state the conclusion that matches them.

3(f)

  • Read the scale at eye level, perpendicular to the scale, to avoid parallax error.
  • Read the bottom of the meniscus.
Original question

Log in or create account

IGCSE, A-Level & AP