Skip to content

IGCSE Physics · November 2022 · Paper 51 · Difficulty 4 · Challenging

Question 4

4

A student investigates the horizontal distance travelled by a metal ball after it rolls off the end of a plastic track. Fig. 4.1 shows the set-up.

The ball rolls down a plastic track. The left-hand side of the track is fixed. The right-hand side can be adjusted so that the ball comes off the track at different angles.

The student measures the horizontal distance that the ball travels from the right-hand end of the track to the point that it hits the floor.

Plan an experiment to investigate how the horizontal distance travelled by the metal ball depends on the angle that the right-hand end of the track makes with the bench.

You are not required to do this experiment.

Fig. 4.1

The following apparatus is available to the student:

  • track with stand, boss and clamp
  • selection of metal balls.

Other apparatus normally available in a school laboratory can also be used.

In your plan, you should:

  • list any additional apparatus required
  • explain briefly how you would do the investigation, including the measurements you would take
  • state the key variables to be kept constant
  • draw a suitable table, with column headings, to show how you would display your readings (you are not required to enter any readings in the table)
  • explain how you would use the results to reach a conclusion.

[7]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

  • Use a protractor, metre rule, plumb line and sand tray. Release the ball and use the sand mark to find where it hits the floor.
  • Use the plumb line to mark the point on the floor below the end of the track. Measure from this point to the impact mark with the metre rule.
  • Measure the end angle with the protractor. Repeat for at least two more angles, using the same ball and release height each time.
  • Make columns headed angle / degrees and distance / cm. Plot distance against angle, or compare the distances, to see how distance depends on angle.
Original question

Log in or create account

IGCSE, A-Level & AP