Skip to content

IGCSE Physics · November 2023 · Paper 53 · Difficulty 2 · Core

Question 2

2

In this experiment, you will investigate the cooling of hot water in surroundings with different temperatures.

Carry out the following instructions, referring to Fig. 2.1 and Fig. 2.2.

(a)
(i)

Pour $100\text{ cm}^3$ of cold water into beaker B. Place the thermometer in the water.

Measure, and record in the appropriate column heading of Table 2.1, the temperature $\theta_1$ of the water.[1]

(ii)

Remove the thermometer from the water in beaker B. Remove the lid from beaker A. Place beaker A inside beaker B, as shown in Fig. 2.2, so that the water in beaker B rises between the sides of the two beakers.

Pour $150\text{ cm}^3$ of hot water into beaker A and replace the lid. Place the thermometer in the water in beaker A.

In Table 2.1, record the temperature $\theta_\text{A}$ of the water at time $t = 0$ and immediately start the stop-watch.

Record the temperature $\theta_\text{A}$ of the water at $t = 30\text{ s}, 60\text{ s}, 90\text{ s}, 120\text{ s}, 150\text{ s}$ and $180\text{ s}$.[1]

(b)
(i)

Remove the thermometer and lid from beaker A. Remove beaker A from beaker B and empty both beakers.

Pour $50\text{ cm}^3$ of cold water and $50\text{ cm}^3$ of hot water into beaker B. Place the thermometer in the water.

Measure, and record in the appropriate column heading of Table 2.1, the temperature $\theta_2$ of the water.[1]

(ii)

Repeat (a)(ii) for this arrangement.[2]

Table 2.1

beaker A
in cold water

$\theta_1 = \text{................... }^\circ\text{C}$
beaker A
in warm water

$\theta_2 = \text{................... }^\circ\text{C}$
$t / \text{s}$$\theta_\text{A} / ^\circ\text{C}$$\theta_\text{A} / ^\circ\text{C}$
0
30
60
90
120
150
180
(c)

Write a conclusion stating in what way the temperature of the water surrounding beaker A affects the rate of cooling of the hot water in beaker A.

Justify your answer by reference to values from your readings.[2]

(d)

Calculate the average cooling rate $R$ for beaker A cooling in cold water. Use your readings for beaker A from Table 2.1 and the equation

$$R = \frac{\theta_{\text{A}0} - \theta_{\text{A}180}}{T}$$

where $T = 180\text{ s}$ and $\theta_{\text{A}0}$ and $\theta_{\text{A}180}$ are the temperatures of the water in beaker A at $t = 0$ and $t = 180\text{ s}$. Include the unit for the cooling rate.

$R = \text{.........................................................}$[2]

(e)

Another student repeats this experiment at the same room temperature.

State one other variable that she controls in order to obtain readings as close as possible to your readings.[1]

(f)

During the experiment, the increase in temperature of the water surrounding beaker A affects the results of the investigation.

Suggest one change to the experiment to reduce this effect.[1]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

2(a)(i)

  • Read the thermometer in the cold water and record $\theta_1$ in the table heading. The value depends on the water you use.

2(a)(ii)

  • Record the hot water temperature at $t = 0\,\mathrm{s}$ and every $30\,\mathrm{s}$ up to $180\,\mathrm{s}$, to at least the nearest $1\,\mathrm{^\circ C}$.
  • The readings should decrease as the hot water cools.

2(b)(i)

  • Measure the mixed water temperature and record $\theta_2$ in the warm water heading. It should be higher than $\theta_1$ because hot water was added.

2(b)(ii)

  • Record the hot water temperature at each time in the warm water column. The readings should decrease as the water cools.
  • The temperature should fall more slowly than in cold surroundings, because the temperature difference is smaller.

2(c)

  • Hot water cools more slowly in warmer surroundings: the smaller temperature difference means a slower transfer of energy.
  • Compare your temperature drops over $180\,\mathrm{s}$. For example, a drop of $18\,\mathrm{^\circ C}$ in cold water and $12\,\mathrm{^\circ C}$ in warm water supports this conclusion.

2(d)

  • Use $R = (\theta_{A0}-\theta_{A180})/T$.
  • For example, with $\theta_{A0} = 80\,\mathrm{^\circ C}$ and $\theta_{A180} = 62\,\mathrm{^\circ C}$, $R = (80-62)\,\mathrm{^\circ C}/180\,\mathrm{s} = \mathbf{0.10}\,\mathrm{^\circ C/s}$. Use your own readings.

2(e)

  • Keep the initial temperature of the hot water in beaker A the same, because this affects its rate of cooling.

2(f)

  • Use a larger volume of water around beaker A, so its temperature rises less as it gains energy.
Original question

Log in or create account

IGCSE, A-Level & AP