Skip to content

IGCSE Physics · November 2023 · Paper 52 · Difficulty 3 · Standard

Question 2

2

In this experiment, you will investigate the resistance of a wire.

Complete the following instructions, referring to Fig. 2.1.

(a)

Close the switch.

Measure the current $I$ in the circuit. $I$ = [1]

(b)

Place the sliding contact at a distance $l$ = 10.0 cm from B.

Measure, and record in Table 2.1, the potential difference (p.d.) $V$ across the length $l$ of resistance wire BC.

Open the switch.

Calculate, and record in Table 2.1, the resistance $R$ of 10.0 cm of the resistance wire using the equation

$$R = \frac{V}{I}$$

where $I$ is the current recorded in (a).

Close the switch.

Repeat the procedure using $l$ = 20.0 cm, 30.0 cm, 40.0 cm and 50.0 cm.[4]

Open the switch.

Table 2.1

$l$/cm$V$/V$R$/Ω
10.0
20.0
30.0
40.0
50.0
(c)

Plot a graph of $R$/Ω ($y$-axis) against $V$/V ($x$-axis). Start both axes at the origin (0,0).

Draw the best-fit line.[4]

(d)

Determine the gradient $G$ of the graph. Show clearly on the graph how you obtained the necessary information.

$G$ = [2]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

2(a)

  • Close the switch and read the ammeter. Record your measured current $I$ in $\mathrm{A}$ to at least two decimal places; it should be less than $1\,\mathrm{A}$.

2(b)

  • Record the measured voltage $V$ for each length to at least one decimal place. The voltage should increase as the length increases.
  • For each row, use $R = V/I$ with your measured voltage and current. Record each resistance in $\Omega$, all to two or all to three significant figures.

2(c)

  • Label the horizontal axis $V/\mathrm{V}$ and the vertical axis $R/\Omega$. Start both at zero and choose scales that use the grid well.
  • Plot each pair of readings within half a small square. Draw a thin, continuous best-fit line through the trend of the points.

2(d)

  • Draw a large triangle on the best-fit line, using at least half the length of the line between the furthest plotted points.
  • Use $G = \Delta R/\Delta V$: divide the vertical change by the horizontal change, using readings from the line. Your numerical answer depends on your graph.
Original question

Log in or create account

IGCSE, A-Level & AP