Skip to content

IGCSE Physics · June 2024 · Paper 52 · Difficulty 3 · Standard

Question 2

2

In this experiment, you will investigate the resistance $R$ of a diode using the circuit shown in Fig. 2.1.

Fig. 2.1
(a)

• Close the switch.

  • Record the voltmeter reading $V$ in the first row of Table 2.1.
  • Record the ammeter reading $I$ in the first row of Table 2.1.
  • Open the switch.

[1]

Table 2.1

resistance between
X and Y/$\Omega$
$V$/V$I$/A$R$/$\Omega$
10
13
20
(b)

• Use a spare connecting lead to connect the 3$\Omega$ resistor in series with the 10$\Omega$ resistor between terminals X and Y, as shown in Fig. 2.2.

Fig. 2.2
  • Record the voltmeter reading $V$ in the second row of Table 2.1.
  • Record the ammeter reading $I$ in the second row of Table 2.1.
  • Open the switch.

[2]

(c)

Connect the 7$\Omega$, 10$\Omega$ and 3$\Omega$ resistors in series between X and Y. Repeat the procedure in (b) with this arrangement of resistors.[1]

(d)

Calculate the resistance $R$ of the diode for each pair of readings of $V$ and $I$ from Table 2.1.

Use the equation $R = \frac{V}{I}$.

Record your answers in Table 2.1.[2]

(e)

As the resistance between terminals X and Y is increased, the current in the circuit changes.

Use your results in Table 2.1 to state the relationship between the current in the circuit and:

(i)

the potential difference (p.d.) $V$ across the diode[1]

(ii)

the resistance $R$ of the diode.[1]

(f)

A student attempts to set up the circuit shown in Fig. 2.1. The student finds that the ammeter does not give a reading when the circuit is complete. The ammeter is not broken.

Suggest what the student may have done incorrectly while setting up the circuit.[1]

(g)

Name a single device that can be used to control the current in the circuit instead of adding extra resistors in series.

Draw the electrical symbol for the device.

name of device

electrical symbol[1]

[Total: 10]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

2(d)

  • Use $R = V/I$ for each row. Divide the voltage across the diode by the current in that row.
  • For example, if $V = 0.6\,\mathrm{V}$ and $I = 0.20\,\mathrm{A}$, then $R = (0.6\,\mathrm{V})/(0.20\,\mathrm{A}) = \mathbf{3.0}\,\mathrm{\Omega}$. Use your own readings.

2(e)(i)

  • As the current decreases, the p.d. across the diode stays roughly constant or decreases slightly.

2(e)(ii)

  • As the current decreases, the resistance of the diode increases.

2(f)

  • The diode may be connected the wrong way round, so it blocks the current.

2(g)

  • Use a variable resistor. Draw a resistor symbol with a diagonal arrow through it.
Worked answer drawing
Original question

Log in or create account

IGCSE, A-Level & AP