In this experiment, you will investigate the deviation of a ray of light passing through a transparent block and determine a quantity called the refractive index $n$ of the block.
Fig. 3.2 is on page 11 of your question paper.
- On Fig. 3.2, draw a normal to the line XY at the point E. Extend your normal above and below XY.
Measure the angle $\theta$ between FE and the normal.
$\theta =$ °[1]
• Extend the line FE until it almost meets the right-hand side of the page and label the end of the line G.
- Place the block on Fig. 3.2 with one of the long sides of the block along the line XY. The top left-hand corner of the block must be at A, as shown in Fig. 3.1.

- On Fig. 3.2, draw around the outline of the block.
- Remove the block.
- Label the outline of the block ABCD, as shown in Fig. 3.1.
- Mark the point where the normal crosses side CD of the block with the letter H.
- Replace the block.
- Switch on the lamp.
- Position the illuminated slit so that a ray of light passes along the line FE towards E.
On Fig. 3.2, mark and label with small crosses (x) two points on the ray that leaves side CD of the block.
Choose the position of the points so that the direction of the ray leaving the block can be accurately drawn.[1]
• Remove the block.
- Draw a straight line through the two crosses to meet side CD of the block.
- Label the point where the line meets CD with the letter J and label the other end of the line K.
- Draw a straight line from E to J. This shows the path of the ray of light through the block.

Measure the length $l$ of EJ.
$l =$ cm[1]
Measure the perpendicular distance $d$ between the line JK and the line FG.
$d =$ cm[1]
Calculate $\frac{d}{l}$.
$\frac{d}{l} =$ [1]
Suggest one source of inaccuracy in this experiment, even if it is carried out very carefully.
[1]
The measurement of a quantity is reproducible if a similar result is obtained when the measurement is repeated by a different method or under different conditions.
Suggest how you can adapt this experiment to check if your value of $\frac{d}{l}$ is reproducible.
You are not required to do this experiment.
[1]
Measure the length $L$ of HJ.
$L =$ cm[1]
Use your value of $l$ from (c)(i) and $L$ from (f)(i) to calculate $\frac{l}{L}$.
$\frac{l}{L} =$ [1]
Calculate a value $n$ for the refractive index of the block. Use the equation shown.
$n =$ [1]
[Total: 10]

