Skip to content

IGCSE Physics · June 2022 · Paper 51 · Difficulty 2 · Core

Question 3

3

In this experiment, you will investigate the resistance of a wire.

Carry out the following instructions, referring to Fig. 3.1.

(a)

Close the switch.

Measure the current $I$ in the circuit.

$I =$ [1]

(b)

Place the sliding contact at a distance $l = 5.0\text{ cm}$ from B.

Measure, and record in Table 3.1, the potential difference (p.d.) $V$ across the length $l$ of resistance wire BC.

Open the switch.

Calculate, and record in Table 3.1, the resistance $R$ of $5.0\text{ cm}$ of the resistance wire using the equation

$$R = \frac{V}{I}$$

Close the switch.

Repeat the procedure in (b) using $l$ values of $25.0\text{ cm}$, $45.0\text{ cm}$, $65.0\text{ cm}$ and $85.0\text{ cm}$.

Open the switch.

$l/\text{cm}$$V/\text{V}$$R/\Omega$
5.0
25.0
45.0
65.0
85.0

[4]

(c)

Plot a graph of $R/\Omega$ ($y$-axis) against $l/\text{cm}$ ($x$-axis). Start both axes at the origin (0,0).

[4]

(d)

Use your graph to determine the resistance $R_{50}$ of $50.0\text{ cm}$ of the resistance wire.

Show clearly on the graph how you obtained the necessary information.

$R_{50} =$ $\Omega$[2]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

3(a)

  • Read the ammeter with the switch closed. Record the current to at least two decimal places, for example $I = \mathbf{0.50}\,\mathrm{A}$; use your own reading.

3(b)

  • Measure $V$ for each wire length. Record each voltage to at least one decimal place; the voltage should increase as the length increases.
  • Use $R = V/I$ for each row. For example, if $V = 0.5\,\mathrm{V}$ and $I = 0.50\,\mathrm{A}$, then $R = 0.5\,\mathrm{V}/0.50\,\mathrm{A} = \mathbf{1.0}\,\Omega$.
  • Use your own readings and give all resistance values to the same number of significant figures: either two or three.

3(c)

  • Label the horizontal axis $l/\mathrm{cm}$ and the vertical axis $R/\Omega$. Start both scales at zero and choose scales that use the graph space well.
  • Plot each pair of readings to within half a small square. Draw a thin, continuous line of best fit through the trend of the points.

3(d)

  • From $50.0\,\mathrm{cm}$ on the horizontal axis, draw a line up to your best-fit line, then across to the resistance axis. Leave these lines visible.
  • Read $R_{50}$ from the vertical axis to the nearest half small square. The numerical answer depends on your own graph.
Original question

Log in or create account

IGCSE, A-Level & AP