Skip to content

IGCSE Physics · June 2022 · Paper 51 · Difficulty 5 · Stretch

Question 4

4

A student investigates the force required to break different beams made from a mixture of sand and cement. All the beams have the same cross-section.

Plan an experiment to investigate the force required to break the beams.

Fig. 4.1 shows the set-up.

You are not required to do this investigation.

Fig. 4.1

The following apparatus is available:

  • a selection of beams made from different ratios of sand and cement and of various lengths
  • triangular blocks to support the beams
  • a metre rule
  • a selection of loads.

You can also use other apparatus and materials that are usually available in a school laboratory.

The student takes all the necessary safety precautions. You are not required to write about safety precautions.

In your plan, you should:

  • explain briefly how to carry out the investigation (you may add to the diagram if it helps your explanation)
  • state the key variables to keep constant
  • draw a table, or tables, with column headings, to show how to display your readings (you are not required to enter any readings in the table)
  • explain how you would use the readings to reach a conclusion.

[7]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

  • Test how the distance between supports affects the breaking load. Keep the beam composition and length the same, and put the load at the same position on each beam.
  • Increase the load until the beam breaks and record the load. Repeat with at least four other support distances, using a new beam each time.
  • Use table headings: support distance $/\,\mathrm{cm}$ and breaking load $/\,\mathrm{N}$. Repeat each test and find the mean breaking load.
  • Plot mean breaking load against support distance, or compare the values, to see how the breaking load changes with distance.
Original question

Log in or create account

IGCSE, A-Level & AP