Skip to content

IGCSE Physics · June 2021 · Paper 52 · Difficulty 3 · Standard

Question 3

3

In this experiment, you will investigate resistance.

Carry out the following instructions, referring to Fig. 3.1.

Fig. 3.1
(a)
(i)

Close the switch.

Measure the current $I$ in the circuit.

$I$ = [1]

(ii)

Place the sliding contact S at C.

Measure the potential difference (p.d.) $V_R$ across the resistor R.

$V_R$ = [1]

Open the switch.

(iii)

Calculate the resistance $R$ of the resistor using the equation $R = \frac{V_R}{I}$.

$R$ = [2]

(b)

Disconnect the voltmeter from terminal B. Connect the voltmeter to terminal C. Close the switch.

  • Place the sliding contact S at a distance $l$ = 20.0 cm from C.
  • Measure, and record in Table 3.1, the reading on the voltmeter.
  • Repeat the procedure using $l$ = 40.0 cm, 60.0 cm, 80.0 cm and 100.0 cm. Open the switch.

Table 3.1

$l$ / cm$V$ / V
20.0
40.0
60.0
80.0
100.0

[1]

(c)

Plot a graph of $V$ / V ($y$-axis) against $l$ / cm ($x$-axis). Start both axes at the origin (0,0).

[4]

(d)

Use your value of $V_R$ from (a)(ii) to find the length $l_R$ of resistance wire that has the same resistance as resistor R. Show clearly on the graph how you obtained the necessary information.

$l_R$ = cm[2]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

3(c)

  • Label the horizontal axis $l\,/\,\mathrm{cm}$ and the vertical axis $V\,/\,\mathrm{V}$. Start both axes at zero and use suitable scales.
  • Plot each measured point to within half a small square, then draw a thin, continuous line of best fit.

3(d)

  • Find $V_R$ on the vertical axis. Draw a horizontal line to the graph, then a vertical line down to the length axis.
  • Read $l_R$ from the length axis. At this voltage, the wire and resistor have the same resistance because the current is the same.
Original question

Log in or create account

IGCSE, A-Level & AP