Skip to content

IGCSE Physics · June 2021 · Paper 52 · Difficulty 4 · Challenging

Question 4

4

A student investigates springs made from different metals.

Plan an experiment to investigate the extension of springs made from different metals.

You are not required to carry out this experiment.

The following apparatus is available:

boss, clamp and stand metre rule springs made from different metals selection of loads with hangers.

You can also use other apparatus and materials that are usually available in a school laboratory.

In your plan, you should:

• write a list of suitable metals for the springs

• draw a diagram of the set up you would use

• explain briefly how to carry out the investigation

• state the key variables to keep constant

• draw a table, or tables, with column headings, to show how to display your readings (you are not required to enter any readings in the table)

• explain how you would use the readings to reach a conclusion.[7]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

  • Use steel, copper and brass springs. Support each spring from a clamp stand, hang a load from its lower end and place a vertical metre rule beside it. Keep the unloaded length, coil diameter, wire diameter and number of turns the same.
  • Measure the unloaded length $l_0$. Add a load and measure the new length $l$. Calculate extension using $x = l-l_0$, with both lengths in $\mathrm{cm}$. Repeat for several loads and for each metal.
  • Make a table with columns for metal, load $F_W/\mathrm{N}$ and extension $x/\mathrm{cm}$. Record the measurements for each spring.
  • Compare extensions at the same load. The metal whose spring has the greatest extension is the easiest to stretch for springs of the same dimensions.
Original question

Log in or create account

IGCSE, A-Level & AP