Skip to content

IGCSE Physics · June 2020 · Paper 52 · Difficulty 3 · Standard

Question 2

2

In this experiment, you will investigate how the potential difference across a resistance wire varies with the length of the wire.

Carry out the following instructions, referring to Fig. 2.1.

Fig. 2.1
(a)
  • Switch on.
  • Place the sliding contact C on the resistance wire at a distance $l = 10.0\text{ cm}$ from B.
  • Measure, and record in Table 2.1, the potential difference $V$ across the length $l$ of the resistance wire.
  • Measure, and record in Table 2.1, the current $I$ in the circuit.
  • Repeat the procedure using $l = 30.0\text{ cm}$, $50.0\text{ cm}$, $70.0\text{ cm}$ and $90.0\text{ cm}$.
  • Switch off.

Table 2.1

$l / \text{cm}$$V / \text{V}$$I / \text{A}$
10.0
30.0
50.0
70.0
90.0

[3]

(b)

Plot a graph of $V / \text{V}$ ($y$-axis) against $l / \text{cm}$ ($x$-axis). Start both axes at the origin $(0,0)$.

[4]

(c)
(i)

Write a conclusion about the value of the current $I$ in the circuit as the position of the sliding contact C is changed.[1]

(ii)

Justify your conclusion by reference to your results.[1]

(d)

Using the graph, determine the potential difference $V_{\text{L}}$ when the length $l = 60.0\text{ cm}$.

Show clearly on the graph how you obtained your result.

$V_{\text{L}} =$ [2]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

2(a)

  • Read both meters at each length. For example, at $l = 10.0, 30.0, 50.0, 70.0, 90.0\,\mathrm{cm}$, $V$ could be $0.2, 0.6, 1.0, 1.4, 1.8\,\mathrm{V}$.
  • The current could be $0.20\,\mathrm{A}$ at each length. Record your own readings; the voltage should increase as the length increases.

2(b)

  • Put $l/\mathrm{cm}$ on the horizontal axis and $V/\mathrm{V}$ on the vertical axis. Start both at zero and choose scales that use most of the grid.
  • Plot each reading within half a small square, then draw a thin, continuous line of best fit.

2(c)(i)

  • The current is approximately constant: moving the contact changes the part of the wire measured by the voltmeter, not the main circuit.

2(c)(ii)

  • Compare the current readings in your table. They should be equal or very close at all five contact positions.

2(d)

  • On your graph, draw a line up from $l = 60.0\,\mathrm{cm}$ to the best-fit line, then across to the voltage axis.
  • Read $V_L$ from your graph to within half a small square. For the example readings in (a), $V_L = \mathbf{1.2}\,\mathrm{V}$.
Original question

Log in or create account

IGCSE, A-Level & AP