Skip to content

IGCSE Physics · June 2020 · Paper 52 · Difficulty 3 · Standard

Question 1

1

In this experiment, you will investigate the period of a pendulum. Carry out the following instructions, referring to Fig. 1.1 and Fig. 1.2.

A pendulum labelled A has been set up for you as shown in Fig. 1.1.

(a)

Adjust the length of the pendulum until the distance $d$ measured from the bottom of the clamp to the centre of the bob is $50.0\text{ cm}$.

Explain how you used the metre rule and set square to measure the length $d$ as accurately as possible. You may draw a diagram.[1]

(b)

Displace the bob slightly and release it so that it swings. Fig. 1.2 shows one complete oscillation of the pendulum.

(i)

Measure the time $t_1$ for 10 complete oscillations.

$t_1 =$ [1]

(ii)

Calculate the period $T_1$ of the pendulum. The period is the time for one complete oscillation.

$T_1 =$ [1]

(c)

Adjust the pendulum until the distance $d$ is $100.0\text{ cm}$.

Repeat the procedure in (b).

$t_2 =$

$T_2 =$ [2]

(d)

Remove the pendulum from the clamp. Using the balance provided, measure the mass $m_A$ of the pendulum. The mass includes the pendulum bob and the thread.

$m_A =$ $\text{g}$[1]

(e)

Using the balance, measure the mass $m_B$ of pendulum B.

$m_B =$ $\text{g}$[1]

(f)

Hang pendulum B from the clamp. Adjust the length of the pendulum until the distance $d$ is $50.0\text{ cm}$.

(i)

Repeat the procedure in (b) and (c).

Distance $d = 50.0\text{ cm}$:

$t_3 =$

$T_3 =$

Distance $d = 100.0\text{ cm}$:

$t_4 =$

$T_4 =$ [1]

(ii)

Explain briefly why timing 10 oscillations gives a more accurate result for the period $T$ than timing 1 oscillation.[1]

(g)
(i)

Using the results $T_1$, $T_2$, $T_3$ and $T_4$, for the period of each pendulum set up, tick (✓) the response that matches your results within the limits of experimental accuracy.

the period $T$ is affected by $d$ only

the period $T$ is affected by both $d$ and $m$

the period $T$ is affected by $m$ only

the period $T$ is not affected by $d$ or $m$[1]

(ii)

Justify your answer to (g)(i) by reference to your results.[1]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

1(a)

  • Hold the metre rule vertically with its zero at the bottom of the clamp. Use a horizontal edge of the set square to line up the centre of the bob with the rule. Read the scale at eye level.

1(b)(i)

  • Time 10 complete swings with a stopwatch. An example reading is $t_1 = \mathbf{14.2}\,\mathrm{s}$; use your measured time.

1(b)(ii)

  • Use $T_1 = t_1/10$ to find the time for one oscillation.
  • For example, $T_1 = 14.2\,\mathrm{s}/10 = \mathbf{1.42}\,\mathrm{s}$. Use your own time.

1(c)

  • Time 10 oscillations at the new length. An example is $t_2 = \mathbf{20.0}\,\mathrm{s}$.
  • Use $T_2 = t_2/10$: for this example, $T_2 = 20.0\,\mathrm{s}/10 = \mathbf{2.00}\,\mathrm{s}$. Use your own time.

1(d)

  • Place both the bob and thread on the balance. An example reading is $m_A = \mathbf{20}\,\mathrm{g}$; record your own reading.

1(e)

  • Place pendulum B on the balance. An example reading is $m_B = \mathbf{40}\,\mathrm{g}$; record your own reading.

1(f)(i)

  • Time 10 oscillations at each length. For example, $t_3 = \mathbf{14.2}\,\mathrm{s}$ and $t_4 = \mathbf{20.0}\,\mathrm{s}$.
  • Use $T_3 = t_3/10$ and $T_4 = t_4/10$. For these readings, $T_3 = 14.2\,\mathrm{s}/10 = \mathbf{1.42}\,\mathrm{s}$ and $T_4 = 20.0\,\mathrm{s}/10 = \mathbf{2.00}\,\mathrm{s}$.
  • Use your own measured times to calculate the periods.

1(f)(ii)

  • The errors from starting and stopping the stopwatch are a smaller fraction of the longer time, so the period found by dividing by 10 is more accurate.

1(g)(i)

  • Tick \textbf{the period is affected by distance $d$ only}. At the same length the periods should be close, even when the mass changes.

1(g)(ii)

  • Compare your results: $T_1$ should be close to $T_3$ and $T_2$ close to $T_4$, while the period increases when the length increases.
Original question

Log in or create account

IGCSE, A-Level & AP