In this experiment, you will investigate the cooling of water.
The apparatus shown in Fig. 3.1 has been assembled for you.

Measure and record the room temperature $\theta_R$ to the nearest 0.5°C.
$\theta_R$ = °C[1]
• Pour approximately 60 cm$^3$ of hot water into the beaker.
- Wait for 30 s.
- Measure and record in Table 3.1, the temperature $\theta$ of the water at time $t = 0$.
- Immediately start the stop-watch and measure the temperature of the water at one-minute intervals for 5 minutes.
Record in Table 3.1 the temperatures to the nearest 1°C.
Table 3.1
| time $t$ /min | temperature $\theta$ / °C |
| 0 | |
| 1 | |
| 2 | |
| 3 | |
| 4 | |
| 5 |
[2]
Suggest why you wait for 30 s before measuring the initial temperature of the hot water.
[1]
State how you ensure that the temperature readings are as accurate as possible.
[1]
Calculate the decrease in temperature $\Delta\theta$ of the hot water during the first two minutes of cooling.
$\Delta\theta$ = °C[1]
Calculate the average rate of cooling $R_1$ of the hot water during the first two minutes of cooling.
Use the equation:
$R_1$ = °C/min[1]
Calculate the average rate of cooling $R_2$ of the hot water during the final two minutes of cooling.
$R_2$ = °C/min[1]
Use your answers to (c)(ii) and (c)(iii) to write a conclusion about the way in which hot water in a beaker cools.
[1]
The water in the beaker is left to continue cooling.
Estimate the temperature of the water $\theta_5$ after a further 5 minutes of cooling.
$\theta_5$ = °C[1]
Estimate the temperature of the water $\theta_{50}$ after a further 50 minutes of cooling.
$\theta_{50}$ = °C[1]
[Total: 11]