Gas/liquid chromatography
مُقدَّم| English | المعنى |
|---|---|
| carrier gas/ˈkærɪə ɡæs/ | غاز حامل |
| retention time/rɪˈtenʃn taɪm/ | زمن الاحتفاظ |
| chromatogram/krəʊˈmætəɡræm/ | مخطط الكروماتوغرافيا |
| mass spectrometer/mæs spekˈtrɒmɪtə/ | جهاز مطياف الكتلة |
Separating a vapour
- When athletes are tested for banned drugs, a tiny urine sample goes through a gas chromatograph. Within minutes it separates dozens of compounds, and each one can be measured.
- Gas/liquid chromatography (GLC) separates volatile substances. Each component comes out at its own retention time 保留时间, and its peak area shows how much is there.
Gas/liquid chromatography route
Follow a volatile sample through column separation to a chromatogram.
In gas chromatography, the time a component takes to pass through the column is its ______ time.
الصعوبة 1/5 · 100 عملة + مكافأة صغيرة عند الإنجاز الأول اليوم
Used to identify components.
Gas chromatography separates a mixture of volatile substances.
الصعوبة 1/5 · 100 عملة + مكافأة صغيرة عند الإنجاز الأول اليوم
They travel through the column at different speeds.
How it works
- the stationary phase is a high-boiling-point non-polar liquid on a solid support.
- the mobile phase is an unreactive carrier gas (e.g. nitrogen).
- the retention time is how long a component takes to pass through.
- A component that interacts more with the stationary phase has a longer retention time.

A gas-liquid chromatogram 色谱图 with retention times and peak areas
In GLC, the mobile phase is:
الصعوبة 1/5 · 100 عملة + مكافأة صغيرة عند الإنجاز الأول اليوم
A carrier gas moves the components past the liquid stationary phase.
A component that interacts more strongly with the stationary phase has a:
الصعوبة 1/5 · 100 عملة + مكافأة صغيرة عند الإنجاز الأول اليوم
More interaction slows it down, so it takes longer to pass through (longer retention time).
Reading the chromatogram
- The area of each peak gives the proportion of that component in the mixture.
A chromatogram shows two peaks with areas in the ratio 3 : 1.
- Total = 3 + 1 = 4 parts.
- So the mixture is 75% of the first component and 25% of the second.
(Peak height can mislead — always use the area.)
The area of each peak in a chromatogram gives:
الصعوبة 1/5 · 100 عملة + مكافأة صغيرة عند الإنجاز الأول اليوم
Peak area is proportional to the amount, so it gives the percentage composition.
Three peaks have areas 50, 30 and 20. What percentage of the mixture is the first component?
الصعوبة 2/5 · 140 عملة + مكافأة صغيرة عند الإنجاز الأول اليوم
50 ÷ (50 + 30 + 20) × 100 = 50%.
Identifying the components
- A peak's retention time matches a known standard run in the same conditions → that names the component.
- Coupling GLC to a mass spectrometer 质谱仪 (GC–MS) confirms each component's identity from its mass spectrum.
- GC–MS is the workhorse of forensics, drug testing and airport security.
What changes the retention time
- A more volatile component (lower boiling point) spends more time in the gas, so it comes out sooner.
- A hotter column or a faster gas flow shortens every retention time, so standards must be run under the same conditions.
- When peaks are roughly triangles, estimate each area as $\tfrac{1}{2} \times \text{base} \times \text{height}$.
Peak A: base 2.0 min, height 40 mm. Peak B: base 1.0 min, height 60 mm.
- Area A ≈ ½ × 2.0 × 40 = 40; area B ≈ ½ × 1.0 × 60 = 30.
- A = 40 ÷ 70 = 57% of the mixture, although peak B is taller.
Three peaks have areas 24, 36 and 60 (same detector response). What percentage of the mixture is the second component?
الصعوبة 2/5 · 140 عملة + مكافأة صغيرة عند الإنجاز الأول اليوم
Total area = 24 + 36 + 60 = 120; 36 ÷ 120 × 100 = 30%.
The column temperature is raised. What happens to the retention times?
الصعوبة 1/5 · 100 عملة + مكافأة صغيرة عند الإنجاز الأول اليوم
Hotter components spend more time in the carrier gas, so they pass through the column faster. Compare retention times only under the same conditions.
Pentane (bp 36 °C) and octane (bp 126 °C) are run through a non-polar GLC column. Which comes out first?
الصعوبة 1/5 · 100 عملة + مكافأة صغيرة عند الإنجاز الأول اليوم
The lower-boiling pentane spends more time in the carrier gas and less in the stationary liquid, so its retention time is shorter.
- Use peak area, not height, for proportions.
- Retention time identifies a substance only when compared with a standard under the same conditions.
- Two compounds can have the same retention time, so GC–MS is used to confirm.
You've got it
- GLC: mobile phase = carrier gas; stationary phase = a non-polar liquid on a solid
- each component has a retention time; more interaction → longer retention
- the peak area = the proportion of that component (areas 3:1 → 75% : 25%)
- match retention time to a standard to identify; GC–MS confirms it