Skip to content

IGCSE Physics · November 2022 · Paper 62 · Difficulty 5 · Stretch

Question 4

4

A student investigates the effect on the resistance of a wire when the tension in the wire is increased. The apparatus is shown in Fig. 4.1. The tension in the wire is increased by adding loads to the hook attached to the wire. The student measures the current $I$ in the wire and the potential difference (p.d.) $V$ across the wire. She determines the resistance $R$ of the wire using the equation $R = \frac{V}{I}$.

The student takes all the necessary safety precautions. You are not required to write about safety precautions.

The following apparatus is available:

  • resistance wire
  • power source, connecting wires and crocodile clips
  • ammeter
  • voltmeter
  • selection of loads and a hanger.
Fig. 4.1

Plan an experiment to investigate the effect on the resistance of a wire when the tension in the wire is increased.

You should:

  • complete the circuit diagram in Fig. 4.1 to show a voltmeter connected to measure the potential difference across the resistance wire
  • explain briefly how you would carry out the investigation
  • state the key variables that you would keep constant
  • draw a table, or tables, with column headings, to show how you would display your readings (you are not required to enter any readings in the table)
  • explain how you would use your readings to reach a conclusion. [7]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

  • Draw a voltmeter symbol connected in parallel across the resistance wire.
  • Attach a load and record its weight, the voltage $V$ and the current $I$. Use $R = V/I$ to calculate the resistance.
  • Repeat with at least two other loads, keeping the length of wire between the crocodile clips constant.
  • Use columns for load $/\mathrm{N}$, $V/\mathrm{V}$, $I/\mathrm{A}$ and $R/\Omega$. Plot resistance against load to see how resistance changes with tension.
Original question

Log in or create account

IGCSE, A-Level & AP