Skip to content

IGCSE Physics · November 2020 · Paper 52 · Difficulty 3 · Standard

Question 2

2

In this experiment, you will investigate the refraction of light in a transparent block.

Carry out the following instructions, using the separate ray-trace sheet provided. Refer to Fig. 2.1.

Fig. 2.1
(a)

• Place the transparent block, largest face down, on the ray-trace sheet supplied. The block should be approximately in the middle of the paper.

  • Draw and label the outline of the block ABCD.
  • Remove the block and draw the normal NL at the centre of side AB. Continue the normal so that it passes through side CD of the block.
  • Label the point F where the normal NL crosses side AB.
  • Label the point G where the normal NL crosses side CD. [1]

(b)
(i)

• Draw the line EF at an angle $i = 30^{\circ}$ to the normal as shown in Fig. 2.1.

  • Place the paper on the pin board.
  • Place two pins $P_1$ and $P_2$ on line EF at a suitable distance apart for this experiment.
  • Replace the block and look from the position of the eye shown in Fig. 2.1, to observe the images of $P_1$ and $P_2$ through side CD of the block. Adjust your line of sight until the images of $P_1$ and $P_2$ appear one behind the other.
  • Place two pins $P_3$ and $P_4$ between your eye and the block so that $P_3$, $P_4$, and the images of $P_1$ and $P_2$ seen through the block, appear one behind the other.
  • Label the positions of $P_1$, $P_2$, $P_3$ and $P_4$.
  • Remove the block and the pins.
  • Draw a line joining the positions of $P_3$ and $P_4$. Continue the line through the outline of the block until it extends to just outside the outline of the block. Label the end of the line K.
  • Label the point H where the line meets side CD.
  • Label the point J where the line meets the normal NL.
  • Draw the line FH. [2]

(ii)

Measure and record the length $a$ of the line GH.

$a = ......................................................... [1]$

(iii)

Measure and record the length $b$ of the line FH.

$b = ......................................................... [1]$

(c)

Measure and record the acute angle $\theta$ between the line NL and the line JK. An acute angle is less than $90^{\circ}$.

$\theta = ......................................................... [2]$

(d)

State one precaution that you took in order to produce an accurate ray-trace.[1]

(e)

A student suggests that $i$ should be equal to $\theta$ within the limits of experimental accuracy. In this experiment, $i = 30^{\circ}$. Suggest a range of values for $\theta$ that match this suggestion for your experiment.

range [1]

(f)

A student plans to test the suggestion that, in this experiment, $i = \theta$ for all possible values of $i$.

Explain briefly how you would test the suggestion.[2]

Tie your ray-trace sheet into this Question Booklet between pages 6 and 7.

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

2(a)

  • Draw the normal at $90^\circ$ to AB through its centre. Label its crossings with AB and CD as F and G respectively.

2(b)(i)

  • Place $P_1$ and $P_2$ on EF at least $5.0\,\mathrm{cm}$ apart, so their line can be drawn accurately.
  • Draw a neat straight line through $P_3$ and $P_4$, extending it through CD to K. Label H where it crosses CD and J where it crosses NL, then join F to H.

2(b)(ii)

  • Place a ruler along GH on your completed ray-trace sheet. Measure from G to H and record $a = GH$ in $\mathrm{mm}$, to the nearest millimetre.
  • H is found using your pins. It is not shown in Fig. 2.1, so this printed figure cannot give a numerical value of $a$.

2(b)(iii)

  • Measure the straight line from F to H on your completed ray-trace sheet. Record $b = FH$ in $\mathrm{mm}$, to the nearest millimetre.
  • Use the refracted line inside the block, not FG or the extended emergent ray. A numerical value needs your measured position of H.

2(c)

  • Measure the acute angle between NL and JK with a protractor. For a rectangular block, the emerging ray is parallel to the incoming ray, so $\theta$ should be about $\mathbf{30}^{\circ}$, within $2^{\circ}$.

2(d)

  • Use a sharp pencil to draw thin lines, so their positions can be identified more accurately.

2(e)

  • Allow up to $3^\circ$ on either side of $30^\circ$: $\mathbf{27}^\circ$ to $\mathbf{33}^\circ$.

2(f)

  • Repeat the ray trace with at least four different values of $i$.
  • Measure $\theta$ each time and compare it with $i$, allowing for experimental uncertainty.
Original question

Log in or create account

IGCSE, A-Level & AP