Skip to content

IGCSE Physics · June 2025 · Paper 52 · Difficulty 3 · Standard

Question 3

3

In this experiment, you will investigate the image formed by a converging lens.

Refer to Fig. 3.1.

(a)
(i)

• Switch on the lamp.

  • Place the screen a distance $D = 80.0\text{ cm}$ from the illuminated object (the triangular hole in the card).
  • Place the lens close to the illuminated object.
  • Move the lens away from the illuminated object until a magnified, sharp image of the illuminated object is formed on the screen.
  • Do not move the illuminated object, the lens or the screen after this image position is found.

Measure, to the nearest $0.1\text{ cm}$, the object distance $x_1$ from the centre of the lens to the illuminated object.

$x_1 =$ cm[1]

(ii)

Continue to move the lens away from the illuminated object until a diminished, sharp image of the illuminated object is formed on the screen.

Measure, to the nearest $0.1\text{ cm}$, the object distance $y_1$ from the centre of the lens to the illuminated object.

$y_1 =$ cm[1]

(iii)

Calculate the value $d = (y_1 - x_1)$.

$d =$ cm[1]

(b)

The focal length $f$ of the lens can be found using the equation:

$$f = \frac{(D^2 - d^2)}{4D}$$

Use the value of $D$ from (a)(i) and $d$ from (a)(iii) to calculate a value $f_1$ for the focal length of the lens.

Give your answer to a suitable number of significant figures for this experiment.

$f_1 =$ cm[2]

(c)
(i)

Repeat the procedure in (a)(i), (a)(ii) and (a)(iii) for an illuminated object to screen distance $D = 100.0\text{ cm}$.

Record your values of $x_2$, $y_2$ and $d$.

$x_2 =$ cm

$y_2 =$ cm

$d =$ cm[1]

(ii)

Calculate a second value $f_2$ for the focal length of the lens using the equation in (b) and your values in (c)(i).

$f_2 =$ cm[1]

(d)

Two quantities can be considered to be equal within the limits of experimental accuracy if their values are within 10% of each other.

State whether your values of $f_1$ and $f_2$ from (b) and (c)(ii) can be considered equal.

Support your statement with a calculation.

statement [2]

(e)
(i)

State one technique you use when doing the experiment to ensure that the image on the screen is focused as clearly as possible.

[1]

(ii)

This experiment is usually done in a darkened room.

Explain how this makes it easier to see when the image is in focus.

[1]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

3(a)(i)

  • When the magnified image is sharp, measure from the object to the centre of the lens. Record your own $x_1$ to the nearest $0.1\,\mathrm{cm}$.

3(a)(ii)

  • When the diminished image is sharp, measure from the object to the centre of the lens and record $y_1$. A value from $57.5\,\mathrm{cm}$ to $62.5\,\mathrm{cm}$ is expected.

3(a)(iii)

  • Use $d = y_1 - x_1$, since $d$ is the distance between the two lens positions.
  • Subtract your measured distances in cm: $d = \mathbf{y_1-x_1}$ in cm.

3(b)

  • Use $f_1 = (D^2-d^2)/(4D)$.
  • Insert $D = 80.0\,\mathrm{cm}$ and your measured $d$: $f_1 = \mathbf{((80.0\,\mathrm{cm})^2-d^2)/(4(80.0\,\mathrm{cm}))}$. Give the result in cm to 2 or 3 significant figures.

3(c)(i)

  • Set $D$ to $100.0\,\mathrm{cm}$ and find the two sharp images again. Record $x_2$ for the magnified image and $y_2$ for the diminished image.
  • Use $d = y_2-x_2$. Subtract your measured distances in cm and record $d = \mathbf{y_2-x_2}$ in cm.

3(c)(ii)

  • Use $f_2 = (D^2-d^2)/(4D)$ with the new value of $d$.
  • Insert $D = 100.0\,\mathrm{cm}$ and your measured $d$: $f_2 = \mathbf{((100.0\,\mathrm{cm})^2-d^2)/(4(100.0\,\mathrm{cm}))}$. Give the result in cm.

3(d)

  • Use percentage difference $= |f_1-f_2|/f_1\times100\%$ to compare your two focal lengths.
  • Insert your values in the same units. If the difference is at most $10\%$, state that they are equal within experimental accuracy; otherwise, state that they are not.

3(e)(i)

  • Move the lens slowly backwards and forwards until the image is as sharp as possible.

3(e)(ii)

  • In a dark room there is better contrast between the image and the rest of the screen, so its edges are easier to see.
Original question

Log in or create account

IGCSE, A-Level & AP