Skip to content

IGCSE Physics · June 2023 · Paper 62 · Difficulty 3 · Standard

Question 2

2

A student investigates the cooling of water.

Fig. 2.1 shows the set-up.

(a)

The thermometer in Fig. 2.2 shows the room temperature $\theta_{\text{R}}$ at the beginning of the experiment. Record $\theta_{\text{R}}$.

$\theta_{\text{R}} =$ [1]

(b)

The student pours $200\text{ cm}^3$ of hot water into a beaker. He places a lid on the beaker. He places the thermometer in the hot water in the beaker.

He records, in Table 2.1, the temperature $\theta$ of the hot water at time $t = 0$. He immediately starts a stop-watch.

He continues recording the temperature in Table 2.1 at $30\text{ s}$ intervals until he has seven sets of readings.

(i)

Complete the column headings in Table 2.1.[1]

(ii)

Write the times in the first column of Table 2.1.

Table 2.1

$t/$$\theta/$
92
87
83
80
78
76
75

[1]

(c)
(i)

Calculate the decrease in temperature $\Delta\theta$ between $t = 0$ and $t = 180\text{ s}$.

$\Delta\theta =$ [1]

(ii)

Calculate the average rate of cooling $R$ of the water using the equation $R = \frac{\Delta\theta}{\Delta t}$, where $\Delta t = 180\text{ s}$. Include the unit.

$R =$ [2]

(d)

A student states that the water cools slowly.

Suggest two changes to the experiment that the student makes to increase the rate of cooling of the hot water without changing the starting temperature of the hot water. Room temperature remains constant.

1

2 [2]

(e)

State one precaution that you would take to obtain accurate temperature readings.

Explain briefly the reason for this precaution.

statement

explanation [2]

(f)

The student uses a measuring cylinder to measure $200\text{ cm}^3$ of water. He takes the reading from the bottom of the meniscus.

Explain the reason for taking the reading at the bottom of the meniscus rather than at the top of the meniscus.[1]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

2(a)

  • Read the top of the liquid column on the thermometer: $\theta_R = \mathbf{23}\,\mathrm{°C}$.

2(b)(i)

  • Use $\mathrm{s}$ for time $t$ and $\mathrm{°C}$ for temperature $\theta$.

2(b)(ii)

  • Start at zero and add $30\,\mathrm{s}$ each time: $\mathbf{0, 30, 60, 90, 120, 150, 180}\,\mathrm{s}$.

2(c)(i)

  • Use $\Delta\theta = \theta_\mathrm{initial} - \theta_\mathrm{final}$.
  • $\Delta\theta = 92\,\mathrm{°C} - 75\,\mathrm{°C} = \mathbf{17}\,\mathrm{°C}$.

2(c)(ii)

  • Use $R = \dfrac{\Delta\theta}{\Delta t}$.
  • $R = \dfrac{17\,\mathrm{°C}}{180\,\mathrm{s}} = \mathbf{0.0944}\,\mathrm{°C/s}$.

2(d)

  • Remove the lid so that energy can leave more easily from the water surface.
  • Blow air over the water surface to increase the rate of cooling.

2(e)

  • Read the thermometer at eye level, with the scale at right angles to your line of sight.
  • This avoids parallax error, which would make the reading appear too high or too low.

2(f)

  • There is very little water between the bottom and top of the meniscus, so the bottom gives the volume of the water more accurately.
Original question

Log in or create account

IGCSE, A-Level & AP