Skip to content

IGCSE Physics · June 2021 · Paper 51 · Difficulty 3 · Standard

Question 3

3

In this experiment, you will investigate the refraction of light in the material of a transparent block.

Carry out the following instructions, using the separate ray-trace sheet provided. You may refer to Fig. 3.1 for guidance.

(a)

• Place the transparent block, largest face down, on the ray-trace sheet supplied. The block should be approximately in the middle of the paper.

  • Draw and label the outline of the block ABCD, as shown in Fig. 3.1.
  • Remove the block and draw a normal at the centre of side AB. Continue the normal so that it passes through side CD of the block. Label the normal NL.
  • Label the point Q where NL crosses AB.
  • Draw a line EF parallel to CD and $2.0\text{ cm}$ below CD.
  • Label the point J where NL crosses EF.
  • Draw a line GH parallel to CD and $7.0\text{ cm}$ below CD.
  • Label the point K where NL crosses GH.

[2]

(b)

• Draw the line PQ at an angle $i = 30^\circ$ to the normal as shown in Fig. 3.1.

  • Place the paper on the pin board.
  • Place two pins, $\text{P}_1$ and $\text{P}_2$, on line PQ at a suitable distance apart for this experiment.
  • Replace the block and look from the position of the eye shown in Fig. 3.1 to observe the images of $\text{P}_1$ and $\text{P}_2$ through side CD of the block. Adjust your line of sight until the images of $\text{P}_1$ and $\text{P}_2$ appear one behind the other.
  • Place a pin $\text{P}_3$ on line EF between your eye and the block so that the images of $\text{P}_1$ and $\text{P}_2$ seen through the block appear behind $\text{P}_3$.
  • Place a pin $\text{P}_4$ on line GH between your eye and the block so that $\text{P}_3$, and the images of $\text{P}_1$ and $\text{P}_2$ seen through the block, appear behind $\text{P}_4$.
  • Label the positions of $\text{P}_1$, $\text{P}_2$, $\text{P}_3$ and $\text{P}_4$.
  • Remove the pins.

[2]

(c)
(i)

Measure and record the length $a$ of the line from J to $\text{P}_3$.

$a =$ [1]

(ii)

Measure and record the length $b$ of the line from K to $\text{P}_4$.

$b =$ [1]

(iii)

Calculate $\dfrac{b}{a}$.

$\dfrac{b}{a} =$ [2]

(d)

State one precaution that you took in order to produce an accurate ray trace.

[1]

(e)

A student plans to test the suggestion that, in this experiment, $\dfrac{b}{a}$ is a constant for all possible values of $i$. List suitable values of $i$ that the student could use.

[2]

Tie your ray-trace sheet into this booklet between pages 8 and 9.

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

3(a)

  • Draw the normal NL through the centre of AB, at right angles to AB, and label its crossing with AB as Q.
  • Draw EF and GH parallel to CD, respectively $2.0\,\mathrm{cm}$ and $7.0\,\mathrm{cm}$ below it. Label their crossings with NL as J and K.

3(b)

  • Draw PQ at $30^\circ$ to the normal, measuring the angle to within $1^\circ$.
  • Place P1 and P2 at least $5.0\,\mathrm{cm}$ apart on PQ. Align P3 and P4 with their images through the block, and label all four pin positions.

3(c)(iii)

  • Use $b/a$: divide your measured length $b$ by $a$, using the same unit for both.
  • The ratio has no unit and should be in the range $\mathbf{1.3}$ to $\mathbf{2.0}$.

3(d)

  • Keep the pins vertical so their positions can be lined up accurately.

3(e)

  • Use, for example, $i=\mathbf{10^\circ}$, $\mathbf{20^\circ}$, $\mathbf{40^\circ}$ and $\mathbf{50^\circ}$.
  • These add four angles below $90^\circ$ and cover a range of $40^\circ$.
Original question

Log in or create account

IGCSE, A-Level & AP