Skip to content

IGCSE Physics · June 2020 · Paper 43 · Difficulty 4 · Challenging

Question 5

5
(a)

Fig. 5.1 shows a plastic cup. The cup contains sand, an electric heater and a thermometer.

The power of the heater is 50W. The mass of the sand in the cup is 550g. The initial temperature of the sand is 20°C. The heater is switched on for 2.0 minutes. The temperature is recorded until the temperature stops increasing. The highest temperature recorded by the thermometer is 33°C.

(i)

Calculate the energy supplied by the heater.

energy = [2]

(ii)

Calculate a value for the specific heat capacity of the sand, using your answer to (a)(i) and the data in the question.

specific heat capacity = [3]

(iii)

Explain why the specific heat capacity of sand may be different from the value calculated in (a)(ii).

[2]

(b)

On a sunny day, the temperature of the sand on a beach is much higher than the temperature of the sea.

Explain why.

[2]

(c)

Draw a labelled diagram to show the structure of a thermocouple thermometer.[3]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

5(a)(i)

  • Use energy $E = Pt$.
  • $E = (50\,\mathrm{W})(120\,\mathrm{s}) = \mathbf{6000}\,\mathrm{J}$.

5(a)(ii)

  • Use the heating equation $E = mc\Delta T$.
  • $c = 6000\,\mathrm{J}/[(0.550\,\mathrm{kg})(33-20)\,\mathrm{°C}] = \mathbf{840}\,\mathrm{J/(kg\,°C)}$.

5(a)(iii)

  • Some energy heats the cup or surroundings rather than the sand.
  • The calculation assumes all the supplied energy heats the sand, so the true specific heat capacity is lower.

5(b)

  • Water has a much higher specific heat capacity than sand.
  • For the same rate of energy supply, water warms less for a given mass.

5(c)

  • Label two wires as copper and constantan. Join them at the hot measuring junction.
  • Connect their other ends to a sensitive voltmeter using copper leads. Label the constantan-to-copper connection as the cold reference junction and show it in melting ice.
Original question

Log in or create account

IGCSE, A-Level & AP