Skip to content

IGCSE Physics · November 2023 · Paper 51 · Difficulty 4 · Challenging

Question 4

4

A student investigates the time taken for water to evaporate to dryness when heated from above.

Fig. 4.1 shows the set-up. The power of the heater is constant.

The following is also available:

  • supply of water at room temperature
  • metre ruler.
Fig. 4.1

Plan an experiment to investigate how one factor affects the time taken for the water to evaporate.

You are not required to do this investigation.

You do not need to write about safety precautions.

You should:

  • state any additional apparatus required
  • explain briefly how you would do the investigation
  • state the key variables that you would keep constant
  • draw a table, or tables, with column headings, to show how you would display your readings (you are not required to enter any readings in the table)
  • explain how you would use your readings to reach a conclusion.

[7]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

  • Use a stopwatch and a measuring cylinder. Measure a volume of water into the dish and time how long it takes for the dish to become dry.
  • Repeat with different volumes of water. Keep the heater height, initial water temperature and surface area of the water the same.
  • **Record volume and evaporation time in the table shown below.**
  • Plot time against volume, or compare the values in the table, to see how the volume affects the time.
Worked answer drawing
Original question

Log in or create account

IGCSE, A-Level & AP