Skip to content

IGCSE Physics · November 2022 · Paper 53 · Difficulty 3 · Standard

Question 1

1

In this experiment, you will investigate the dimensions of a boiling tube.

The apparatus has been set up for you.

Carry out the following instructions, referring to Fig. 1.1.

Fig. 1.1
(a)

Pour approximately 3 cm$^{3}$ of water into the boiling tube.

Measure the height $h_{0}$ of the water level from the bench, as shown in Fig. 1.1.

$h_{0}$ = cm

Suggest one precaution that is taken when measuring the height of the water level to ensure the reading is accurate.

You may draw a diagram if it helps your explanation.[1]

(b)

Using the dropping pipette, and measuring cylinder if necessary, add a further volume of water $V = 5.0 \text{ cm}^{3}$ to the water already in the boiling tube.

Measure, and record in Table 1.1, the new height $h$ of the water level from the bench.

Repeat this procedure, adding 5.0 cm$^{3}$ of water each time so that the total volume of water added $V = 10.0 \text{ cm}^{3}$, 15.0 cm$^{3}$, 20.0 cm$^{3}$ and 25.0 cm$^{3}$.[1]

Table 1.1

$V/ \text{cm}^{3}$$h/ \text{cm}$$H/ \text{cm}$
5.0
10.0
15.0
20.0
25.0
(c)

For each value of $V$, calculate, and record in Table 1.1, the increase in height $H$ of the water in the boiling tube. Use your value of $h_{0}$ from (a), the values of $h$ in Table 1.1 and the equation $H = (h - h_{0})$.[1]

(d)

Plot a graph of $V/ \text{cm}^{3}$ ($y$-axis) against $H/ \text{cm}$ ($x$-axis).[4]

(e)
(i)

Determine the gradient of the graph. Show clearly on the graph how you obtained the necessary information.

gradient = [1]

(ii)

Calculate $D$, the inside diameter of the boiling tube.

Use the equation $D = \sqrt{\frac{4G}{\pi}}$, where $G$ is numerically equivalent to the gradient in (e)(i).

$D$ = cm[1]

(f)

Suggest why it is important to add a small amount of water at the start of the experiment.[1]

(g)

A student uses this experiment to measure $D$ for a small test-tube of diameter approximately 1.2 cm and length 7.5 cm. He adds water in volumes of 1.0 cm$^{3}$ at a time.

State and explain one reason why this is not an accurate method to use for this test-tube.[1]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

1(a)

  • Measure $h_0$ from the bench to the water level; the value depends on your apparatus.
  • Read the ruler at eye level to avoid parallax error.

1(b)

  • Measure $h$ from the bench after each addition. Each height should be greater than $h_0$ and greater than the one before it.

1(c)

  • Use $H = h - h_0$ for each row; this gives the rise above the initial water level.
  • For example, if $h = 6.5\,\mathrm{cm}$ and $h_0 = 5.0\,\mathrm{cm}$, then $H = 6.5\,\mathrm{cm} - 5.0\,\mathrm{cm} = \mathbf{1.5}\,\mathrm{cm}$. Use the same number of decimal places in every row.

1(d)

  • Label the horizontal axis $H/\mathrm{cm}$ and the vertical axis $V/\mathrm{cm^3}$.
  • Choose scales so the points use at least half the grid in each direction.
  • Plot each point within half a small square, then draw a thin, well-judged line of best fit.

1(e)(i)

  • Draw a large triangle on the best-fit line and read the change in $V$ and the change in $H$ from its corners.
  • Use $G = \Delta V/\Delta H$. For example, $G = 25.0\,\mathrm{cm^3}/7.5\,\mathrm{cm} = \mathbf{3.33}\,\mathrm{cm^2}$. Your value depends on your graph.

1(e)(ii)

  • Use $D = \sqrt{4G/\pi}$, where $G$ is the gradient of your graph.
  • For example, if $G = 3.33\,\mathrm{cm^2}$, then $D = \sqrt{4(3.33\,\mathrm{cm^2})/\pi} = \mathbf{2.06}\,\mathrm{cm}$. Your result depends on your gradient.

1(f)

  • The inside diameter near the base is not uniform. The first water fills this part, so later height changes are measured in the uniform section.

1(g)

  • Each added volume is small, so the uncertainty in measuring it is a large percentage of the volume.
Original question

Log in or create account

IGCSE, A-Level & AP