Skip to content

IGCSE Physics · November 2021 · Paper 52 · Difficulty 5 · Stretch

Question 4

4

A student investigates the strengths of wires made from different metals by measuring the force required to break the wires.

The apparatus is shown in Fig. 4.1. A wire is held by a clamp at one end and a load is suspended from the other end. The load is increased until the wire breaks. The student takes all the necessary safety precautions.

Fig. 4.1

Plan an experiment to investigate the force required to break wires made from different metals. You are not required to do the investigation.

The following apparatus is available:

clamps and stands

a selection of masses with a suitable hanger metre rule

a selection of wires made from different metals.

You can also use other apparatus and materials that are usually available in a school laboratory.

In your plan, you should:

  • write a list of suitable metals for the wires you would investigate
  • explain briefly how you would do the investigation
  • state the key variables that you would keep constant
  • draw a table, or tables, with column headings, to show how you would display your readings (you are not required to enter any readings in the table)
  • explain how you would use the results to reach a conclusion.

You may add to the diagram if it helps your explanation.

You are not required to write about the safety precautions that the student should take.[7]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

  • Test copper, aluminium and iron wires. Keep their diameter and length the same.
  • Add masses until a wire breaks. Record the total mass, including the hanger. Calculate the breaking force using $F_W=mg$, with $m$ in $\mathrm{kg}$ and $g$ in $\mathrm{N/kg}$, giving $F_W$ in $\mathrm{N}$.
  • Repeat with fresh wires of each metal and calculate the mean breaking force. Use table headings: metal, breaking force / N for each trial, and mean breaking force / N.
  • Compare the mean breaking forces. The metal with the $\textbf{largest mean breaking force}$ is the strongest for this wire diameter.
Original question

Log in or create account

IGCSE, A-Level & AP