Skip to content

IGCSE Physics · November 2021 · Paper 51 · Difficulty 2 · Core

Question 1

1

In this experiment, you will investigate the stretching of a spring.

Carry out the following instructions, referring to Fig. 1.1.

(a)

The metre rule is clamped in position near to the spring. Do not change the position of the metre rule.

(i)

Write down the scale readings in mm from the metre rule at the top and bottom of the spring.

top reading = mm

bottom reading = mm[1]

(ii)

Using the two readings, calculate the length $l_{0}$ of the spring in mm. Record $l_{0}$ in Table 1.1. The value $l_{0}$ is the length of the spring when the load $L = 0.00\text{N}$.[1]

(b)

• Suspend a load $L = 0.20\text{N}$ from the spring. Record the new length $l$ of the spring in Table 1.1.

  • Use the equation $e = (l - l_{0})$ to calculate the extension $e$ of the spring. Record the value of $e$ in Table 1.1.
  • Repeat the procedure using loads $L = 0.40\text{N}$, $L = 0.60\text{N}$, $L = 0.80\text{N}$ and $L = 1.00\text{N}$. Record all the readings and results in the Table 1.1.

Table 1.1

L/Nl/mme/mm
0.000
0.20
0.40
0.60
0.80
1.00

[3]

(c)

Plot a graph of $e/\text{mm}$ ($y$-axis) against $L/\text{N}$ ($x$-axis).

[4]

(d)

Fig. 1.2 shows the unstretched spring and the spring with a load. On Fig. 1.2, show clearly the distances $l_{0}$, $l$ and $e$.

Fig. 1.2 [2]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

1(a)(i)

  • Read the metre rule level with the top and bottom of the spring. Keep your eye level with each point to avoid parallax error.
  • Record both readings in $\mathrm{mm}$. The top reading is smaller because the scale increases downwards. The diagram has no scale divisions, so numerical readings must come from the apparatus.

1(a)(ii)

  • Use $l_0 = \text{bottom reading} - \text{top reading}$, because the scale increases downwards. Record the result in $\mathrm{mm}$ at $L = 0.00\,\mathrm{N}$.

1(b)

  • For each load, measure the spring length $l$ in $\mathrm{mm}$. The lengths should increase as the load increases.
  • Use $e = l - l_0$ for each load. Enter each extension in $\mathrm{mm}$; at zero load, $e = 0\,\mathrm{mm}$.

1(c)

  • Label the horizontal axis $L / \mathrm{N}$ and the vertical axis $e / \mathrm{mm}$. Choose scales that use most of the grid.
  • Plot each pair of readings to within half a small square. Draw a thin, continuous line of best fit through the trend of the points.

1(d)

  • Mark $l_0$ from the top to the bottom of the unloaded spring, and $l$ from the top to the bottom of the loaded spring.
  • Mark $e$ between the two bottom positions: it is the extra length, $e = l-l_0$.
Original question

Log in or create account

IGCSE, A-Level & AP