Skip to content

IGCSE Physics · November 2020 · Paper 42 · Difficulty 4 · Challenging

Question 10

10

Fig. 10.1 shows an incomplete electrical circuit.

(a)
(i)

A student completes the circuit and measures the current in the 6.0 $\Omega$ resistor.

On Fig. 10.1, draw an ammeter symbol in one gap and straight lines to indicate wires in the other gaps to show how the student should do this.[1]

(ii)

A voltmeter is connected to measure the potential difference (p.d.) across the 4.0 $\Omega$ resistor.

On Fig. 10.1, draw a voltmeter symbol connected in the correct position.[2]

(iii)

With the circuit completed, the current in the 2.0 $\Omega$ resistor is 2.5 A.

Calculate the current in the 6.0 $\Omega$ resistor.

current = [4]

(b)

Fig. 10.2 shows the same electrical circuit with an alternating current (a.c.) power supply and a wire in the gap AB.

On Fig. 10.2, draw a diode symbol in one gap and a straight line to indicate a wire in the other gap so that there is a current from right to left in the 4.0 $\Omega$ resistor and an alternating current in the 2.0 $\Omega$ resistor.[2]

[Total: 9]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

10(a)(i)

  • Draw an ammeter, a circle containing A, in gap AB; join CD and EF with straight wires.

10(a)(ii)

  • Draw a voltmeter, a circle containing V, connected in parallel across the $4.0\,\mathrm{\Omega}$ resistor.

10(a)(iii)

  • Use $V = IR$ across the $2.0\,\mathrm{\Omega}$ resistor: $V = (2.5\,\mathrm{A})(2.0\,\mathrm{\Omega}) = 5.0\,\mathrm{V}$.
  • The parallel $4.0\,\mathrm{\Omega}$ resistor has the same voltage, so $I_4 = V/R_4 = (5.0\,\mathrm{V})/(4.0\,\mathrm{\Omega}) = 1.25\,\mathrm{A}$.
  • The series current is the sum of the branch currents: $I_6 = I_2 + I_4 = 2.5\,\mathrm{A}+1.25\,\mathrm{A} = 3.75\,\mathrm{A} \approx \mathbf{3.8}\,\mathrm{A}$.

10(b)

  • Draw the diode in gap EF with its triangle pointing $\textbf{left}$ and its bar on the left. It allows current through the $4.0\,\mathrm{\Omega}$ resistor only from right to left.
  • Draw a wire across CD so the $2.0\,\mathrm{\Omega}$ branch carries current in both directions.
Original question

Log in or create account

IGCSE, A-Level & AP