Skip to content

IGCSE Physics · June 2022 · Paper 61 · Difficulty 4 · Challenging

Question 4

4

A student investigates the force required to break different beams made from a mixture of sand and cement. All the beams have the same cross-section.

Plan an experiment to investigate the force required to break the beams.

Fig. 4.1 shows the set-up.

Fig. 4.1

The following apparatus is available:

  • a selection of beams made from different ratios of sand and cement and of various lengths
  • triangular blocks to support the beams
  • a metre rule
  • a selection of loads.

You can also use other apparatus and materials that are usually available in a school laboratory.

The student takes all the necessary safety precautions. You are not required to write about safety precautions.

In your plan, you should:

  • explain briefly how to carry out the investigation (you may add to the diagram if it helps your explanation)
  • state the key variables to keep constant
  • draw a table, or tables, with column headings, to show how to display your readings (you are not required to enter any readings in the table)
  • explain how you would use the readings to reach a conclusion.

[7]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

  • Test the distance between supports, measured with a metre rule. Add loads halfway between the supports until the beam breaks. Record the breaking load in $\mathrm{N}$; use small load steps near breaking.
  • Repeat at four more support distances. Keep beam length, composition and cross-section constant. Always put the load halfway between the supports.
  • Repeat each test with fresh, identical beams and find the mean breaking load. Table headings: support distance $/\,\mathrm{cm}$, breaking load $/\,\mathrm{N}$, mean breaking load $/\,\mathrm{N}$.
  • Plot mean breaking load against support distance, or compare the means, to see how the force needed to break the beam depends on support distance.
Original question

Log in or create account

IGCSE, A-Level & AP