Skip to content

IGCSE Physics · June 2021 · Paper 62 · Difficulty 3 · Standard

Question 4

4

A student investigates springs made from different metals.

Plan an experiment to investigate the extension of springs made from different metals.

The following apparatus is available:

boss, clamp and stand metre rule springs made from different metals selection of loads with hangers.

You can also use other apparatus and materials that are usually available in a school laboratory.

In your plan, you should:

• write a list of suitable metals for the springs

• draw a diagram of the set up you would use

• explain briefly how to carry out the investigation

• state the key variables to keep constant

• draw a table, or tables, with column headings, to show how to display your readings (you are not required to enter any readings in the table)

• explain how you would use the readings to reach a conclusion.[7]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

  • Use steel, copper and brass springs. Draw a spring hanging from a clamp, with a load on its lower end and a metre rule beside it.
  • Measure the unloaded length, then add a load and measure the new length. Subtract to find the extension. Repeat for several loads and for each metal.
  • Keep the original spring length and wire diameter the same. Make a table with columns for metal, load in $\mathrm{N}$ and extension in $\mathrm{cm}$.
  • Plot extension against load for each spring. Compare the extensions at the same load to see how the metal affects the extension.
Original question

Log in or create account

IGCSE, A-Level & AP