Skip to content

IGCSE Physics · June 2021 · Paper 61 · Difficulty 4 · Challenging

Question 3

3

A student investigates the refraction of light through a transparent block.

Fig. 3.1 shows the transparent block ABCD on the student’s ray-trace sheet.

(a)

• Draw a normal at the centre of side AB. Continue the normal so that it reaches the bottom of the ray-trace sheet. Label the normal NL.

  • Label the point Q where NL crosses AB.

[1]

(b)

• Draw a line EF parallel to CD and 2.0cm below CD.

  • Label the point J where NL crosses EF.
  • Draw a line GH parallel to CD and 7.0cm below CD.
  • Label the point K where NL crosses GH.

[1]

(c)
(i)

Draw a line PQ at an angle $i = 30^{\circ}$ to the normal and on the left-hand side of the normal above the block.[1]

(ii)

The student places two pins $P_1$ and $P_2$ on line PQ. Fig. 3.1 is not drawn full size. Suggest a suitable distance apart for pins $P_1$ and $P_2$ in this type of experiment.

distance apart [1]

(d)

The student observes the images of $P_1$ and $P_2$ through side CD of the block. She adjusts her line of sight until the images of $P_1$ and $P_2$ appear one behind the other.

She places a pin $P_3$ on line EF and a pin $P_4$ on line GH so that $P_3$, and the images of $P_1$ and $P_2$ seen through the block, appear behind pin $P_4$.

(i)

On Fig. 3.1, measure the length $a$ of the line from J to $P_3$.

$a$ = [1]

(ii)

On Fig. 3.1, measure the length $b$ of the line from K to $P_4$.

$b$ = [1]

(iii)

Calculate $\frac{b}{a}$.

$\frac{b}{a}$ = [2]

(e)

State one precaution that you would take in this type of experiment in order to produce an accurate ray trace.

[1]

(f)

A student plans to test the suggestion that, in this experiment, $\frac{b}{a}$ is a constant for all possible values of $i$. List suitable values of $i$ that the student could use.

[2]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

3(a)

  • Draw NL through the centre of AB at $90^\circ$ to AB. Label the crossing Q and extend the normal down the sheet.

3(b)

  • Draw EF parallel to CD and $2.0\,\mathrm{cm}$ below it. Draw GH parallel to CD and $7.0\,\mathrm{cm}$ below it, giving a $5.0\,\mathrm{cm}$ gap between EF and GH.
  • Label the crossing of EF with NL as J, and the crossing of GH with NL as K.

3(c)(i)

  • Draw PQ above the block and to the left of the normal, at $30^\circ$ to the normal.

3(c)(ii)

  • Place the pins $\mathbf{10}\,\mathrm{cm}$ apart. A wide separation helps with accurate alignment.

3(d)(i)

  • Measure horizontally from J on the normal to $P_3$: $a = \mathbf{2.4}\,\mathrm{cm}$.

3(d)(ii)

  • Measure horizontally from K on the normal to $P_4$: $b = \mathbf{5.3}\,\mathrm{cm}$.

3(d)(iii)

  • Use the ratio $b/a$ to compare the two lengths.
  • $b/a = (5.3\,\mathrm{cm})/(2.4\,\mathrm{cm}) = \mathbf{2.21}$. The units cancel.

3(e)

  • Keep the pins vertical so that their positions can be aligned accurately.

3(f)

  • Use, for example, $\mathbf{10^\circ}$, $\mathbf{20^\circ}$, $\mathbf{40^\circ}$ and $\mathbf{50^\circ}$. These give four more angles over a range of $40^\circ$.
Original question

Log in or create account

IGCSE, A-Level & AP