Skip to content

IGCSE Physics · June 2021 · Paper 51 · Difficulty 3 · Standard

Question 1

1

In this experiment, you will investigate the period of a pendulum. Carry out the following instructions, referring to Fig. 1.1 and Fig. 1.2.

Fig. 1.2

A pendulum has been set up for you as shown in Fig. 1.1.

(a)

Measure the distance $d$ between the bottom of the split cork and the floor.

$d =$ $\text{cm}$[1]

This distance $d$ must remain constant throughout the experiment.

(b)

• Adjust the length of the pendulum until the distance $x$, measured from the centre of the bob to the floor, is $50.0\text{ cm}$.

  • Displace the bob slightly and release it so that it swings. Fig. 1.2 shows one complete oscillation of the pendulum.
  • Measure, and record in Table 1.1, the time $t$ for 10 complete oscillations.
  • Calculate, and record in Table 1.1, the period $T$ of the pendulum. The period is the time for one complete oscillation.
  • Calculate, and record in Table 1.1, $T^2$. [2]

Table 1.1

$x / \text{cm}$$t / \text{s}$$T / \text{s}$$T^2 / \text{s}^2$
$50.0$
$45.0$
$40.0$
$35.0$
$30.0$
(c)

Repeat the procedure in (b) using $x = 45.0\text{ cm}$, $40.0\text{ cm}$, $35.0\text{ cm}$ and $30.0\text{ cm}$.[3]

(d)

Plot a graph of $T^2 / \text{s}^2$ ($y$-axis) against $x / \text{cm}$ ($x$-axis). You do not need to start your axes at the origin $(0,0)$.

[4]

(e)

Explain why timing 10 oscillations gives a more accurate result for the period $T$ than timing one oscillation.

[1]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

1(a)

  • Use a metre rule to measure vertically from the bottom of the split cork to the floor. Do not measure the printed diagram: it is not full size.
  • The expected range is $d = \mathbf{95\text{–}105}\,\mathrm{cm}$. Record your actual measurement and keep this distance fixed throughout the experiment.

1(b)

  • Time 10 complete oscillations. The measured time $t$ should be about $13$ to $15\,\mathrm{s}$.
  • Use $T = t/10$ to find the period, then use $T^2 = (t/10)^2$ to fill the last column.

1(c)

  • For each measured time $t$, use $T = t/10$, then calculate $T^2 = (t/10)^2$.
  • As $x$ decreases, the pendulum gets longer, so $T^2$ should increase. Give all $T^2$ values to the same 3 or 4 significant figures.

1(d)

  • Label the horizontal axis $x/\mathrm{cm}$ and the vertical axis $T^2/\mathrm{s^2}$. Choose scales that use the graph space well.
  • Plot each measured point within half a small square and draw a thin, continuous best-fit line.

1(e)

  • The reaction-time error is a smaller fraction of the longer measured time, so dividing by 10 gives a more accurate period.
Original question

Log in or create account

IGCSE, A-Level & AP