Skip to content

IGCSE Physics · March 2022 · Paper 52 · Difficulty 3 · Standard

Question 3

3

In this experiment, you will investigate the refraction of light using a transparent block.

Carry out the following instructions, using the separate ray-trace sheet provided.

You may refer to Fig. 3.1 for guidance.

(a)

• Place the transparent block approximately in the centre of the ray-trace sheet. Carefully draw round the block and label the corners ABCD, as shown in Fig. 3.1.

  • Remove the block from the ray-trace sheet.
  • Draw a normal to line AB at a point $2\text{ cm}$ from A. Label the normal NL, as shown in Fig. 3.1.
  • Draw a line NE, $8\text{ cm}$ long and at an angle $\theta_1 = 15^\circ$, as indicated in Fig. 3.1.

[2]

(b)

• Replace the block in exactly the same position as in (a).

  • Place the plane mirror on line CD with its face against the block, as shown in Fig. 3.1.
  • Place two pins, $\text{P}_1$ and $\text{P}_2$, on line NE a suitable distance apart for accurate ray tracing.
  • Label the positions of pins $\text{P}_1$ and $\text{P}_2$.
  • View the images of pins $\text{P}_1$ and $\text{P}_2$ through the block from the direction indicated by the eye in Fig. 3.1. Place two pins, $\text{P}_3$ and $\text{P}_4$, a suitable distance apart so that pins $\text{P}_3$ and $\text{P}_4$, and the images of pins $\text{P}_1$ and $\text{P}_2$, all appear exactly one behind the other.
  • Label the positions of pins $\text{P}_3$ and $\text{P}_4$.
  • Remove the block, mirror and pins from the ray-trace sheet.

[1]

(c)

• Draw a line through $\text{P}_3$ and $\text{P}_4$ and extend this line $4\text{ cm}$ below CD.

  • Label the point at which this line meets AB with the letter G.
  • Label the lower end of this line with the letter H.

[1]

(d)
(i)

• Draw a new line NE, $8\text{ cm}$ long and at an angle $\theta_2 = 35^\circ$, as indicated in Fig. 3.1.

  • Repeat the steps in (b).
  • Draw a line joining the new positions of pins $\text{P}_3$ and $\text{P}_4$ and extend this line $4\text{ cm}$ below CD.
  • Label the point at which this line meets AB with the letter R.
  • Label the lower end of this line with the letter S.
  • Label the point at which GH and RS cross with the letter T.

[2]

(ii)

Measure the angle $\beta$, where $\beta$ is the angle between lines GT and RT.

$\beta =$ [1]

(iii)

A student suggests that the angle $\beta$ should be equal to $\theta_\text{s}$, where $\theta_\text{s}$ is calculated using the equation

$$\theta_\text{s} = \theta_2 - \theta_1.$$

State whether your results support this suggestion. Justify your answer by reference to values from your results.

statement

justification

[2]

(e)

Suggest one precaution to take in this type of experiment to ensure accurate results.

[1]

(f)

Suggest one reason why different students, all carrying out this experiment carefully, may not obtain identical results.

[1]

[Total: 11]

Tie your ray-trace sheet into this booklet between pages 8 and 9.

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

3(a)

  • Draw the outline of the block and label its corners ABCD. Draw NL perpendicular to AB at a point $2\,\mathrm{cm}$ from A.
  • Draw NE $8\,\mathrm{cm}$ long at $15^{\circ}$ to the normal, on the side shown.

3(b)

  • Place each pair of pins at least 5 cm apart so their alignment is easier to judge. Keep the pins upright and label all four positions.

3(c)

  • Use a ruler to draw a straight line through $P_3$ and $P_4$. Extend it $4\,\mathrm{cm}$ below $CD$. Label its intersection with $AB$ as $G$ and its lower end as $H$.

3(d)(i)

  • Draw the new $NE$ line $8\,\mathrm{cm}$ long at $35^{\circ}$ to the normal. Repeat the pin alignment and mark the new positions of $P_3$ and $P_4$.
  • Draw a straight line through the new pin positions and extend it $4\,\mathrm{cm}$ below $CD$. Label its intersection with $AB$ as $R$ and its lower end as $S$. Label the crossing of $GH$ and $RS$ as $T$.

3(d)(ii)

  • Measure the angle between GT and RT with a protractor: $\beta$ should be about $\mathbf{20}^{\circ}$.

3(d)(iii)

  • Use $\theta_s=\theta_2-\theta_1$. Substituting gives $\theta_s=35^{\circ}-15^{\circ}=\mathbf{20}^{\circ}$.
  • If your measured $\beta$ is about $20^{\circ}$, the results support the suggestion. Quote your measured $\beta$ and compare it with $20^{\circ}$ to justify your statement.

3(e)

  • Keep the pins upright so their apparent positions can be lined up accurately.

3(f)

  • It is difficult to align the pins exactly, even with care. Different students may therefore draw slightly different rays.
Original question

Log in or create account

IGCSE, A-Level & AP