Skip to content

IGCSE Physics · November 2025 · Paper 62 · Difficulty 3 · Standard

Question 1

1

A student investigates the reflection of light by a plane mirror. The student’s ray-trace is shown full-size in Fig. 1.1.

Fig. 1.1
(a)

The student:

  • draws line LN
  • labels the mid-point of LN with the letter M
  • draws a line PR parallel to LN and $10.0\text{ cm}$ below it

On Fig. 1.1, draw a normal to LN at the point M. Extend the normal downwards until it crosses the line PR. Label the point at which the normal crosses PR with the letter Q.[1]

(b)

On Fig. 1.1, draw a line $14.0\text{ cm}$ long from point M at an angle $\theta = 10^\circ$, as shown in Fig. 1.2. Label the other end of the line O.[2]

(c)

The student:

  • places the reflecting surface of a mirror along the line LN, with its reflecting surface facing the bottom of the page, and with the centre of the mirror at M
  • positions a light source and slit so that a ray of light passes along the line OM towards M
  • marks two small crosses $\text{X}_1$ and $\text{X}_2$, a suitable distance apart on the ray reflected from the mirror
  • removes the mirror and the illuminated slit.
(i)

On Fig. 1.1, draw a line joining M to $\text{X}_1$ and $\text{X}_2$.

Continue the line until it crosses the line PR and label the point where it crosses PR with the letter T.[1]

(ii)

Measure the length $a$ of the line QT in centimetres to the nearest millimetre and the length $b$ of the line MT in centimetres to the nearest millimetre. Record your measurements below and in Table 1.1.

$a =$ $\text{cm}$

$b =$ $\text{cm}$[1]

(d)

Calculate the ratio $r = \frac{a}{b}$. Record your answer in Table 1.1.

Give your answer to 2 significant figures.

Table 1.1

$\theta / ^\circ$$a / \text{cm}$$b / \text{cm}$$r = \frac{a}{b}$
10
204.212.80.33
306.813.70.50

[2]

(e)

The student repeats the procedure in (b) and (c) for values of $\theta = 20^\circ$ and $\theta = 30^\circ$.

The student’s results are recorded in Table 1.1.

The student states that $r$ is directly proportional to $\theta$.

State if you agree with the student.

Use values from Table 1.1 to justify your answer.

statement

justification [2]

(f)

Suggest what the student can do to have more confidence in their answer to part (e).[1]

(g)

Suggest one source of inaccuracy in this experiment, even if it is carried out very carefully.[1]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

1(a)

  • Draw a line through M at $90^\circ$ to LN, continuing down to PR. Label the intersection $\textbf{Q}$.

1(b)

  • From M, draw MO at $\mathbf{10^\circ}$ to the normal MQ, on the side shown in Fig. 1.2. Make MO $\mathbf{14.0}\,\mathrm{cm}$ long and label its other end O.

1(c)(i)

  • Draw a straight line through M and the two crosses. Extend it to PR and label the intersection $\textbf{T}$.

1(c)(ii)

  • Measure QT and MT to the nearest millimetre: $a = \mathbf{1.7}\,\mathrm{cm}$ and $b = \mathbf{10.3}\,\mathrm{cm}$.

1(d)

  • Use $r = a/b$.
  • $r = (1.7\,\mathrm{cm})/(10.3\,\mathrm{cm}) = \mathbf{0.17}$ to two significant figures.

1(e)

  • Yes. If $r$ is directly proportional to $\theta$, the ratio $r/\theta$ should be approximately constant.
  • For $10^\circ$, $20^\circ$ and $30^\circ$, the ratios are approximately $0.017$, $0.0165$ and $0.0167$ per degree, which are close.

1(f)

  • Repeat the investigation for \textbf{more values of $\theta$} to see whether the pattern continues.

1(g)

  • The light ray has a finite width, so its centre is difficult to locate exactly.
Original question

Log in or create account

IGCSE, A-Level & AP