Skip to content

IGCSE Physics · November 2025 · Paper 42 · Difficulty 4 · Challenging

Question 6

6
(a)

Fig. 6.1 shows successive crests of a water wave approaching a boundary.

Fig. 6.1
(i)

The speed of the waves in region B is lower than the speed of the waves in region A.

On Fig. 6.1, draw the crests of the waves in region B.[3]

(ii)

State the wave effect that occurs as the wave crosses the boundary between region A and region B.[1]

(b)
(i)

Light can be totally internally reflected when striking the boundary between two different regions.

State two conditions that are necessary for total internal reflection to occur.

1

2 [2]

(ii)

State two advantages of using optical fibres for transmitting high speed broadband.

1

2 [2]

[Total: 8]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

6(a)(i)

  • Join each new crest to its corresponding incident crest at the boundary.
  • Draw the crests in B at a smaller angle to the boundary, continuing with the same direction of slant.
  • Keep the crests parallel, with smaller spacing than in A: lower speed at unchanged frequency means a shorter wavelength.

6(a)(ii)

  • The wave effect is refraction, caused by a change in wave speed.

6(b)(i)

  • Light must approach the boundary from the region where it travels more slowly, towards the region where it travels faster.
  • Its angle of incidence must be greater than the critical angle, measured from the normal.

6(b)(ii)

  • Optical fibres support high data transmission rates, carrying more information each second.
  • They have little signal loss, allowing transmission over long distances.
Original question

Log in or create account

IGCSE, A-Level & AP