Bỏ qua nội dung

OxfordAQA · International GCSE

Vật lý

Giấy thi, mẫu đề và tài liệu chương trình cho khóa học này.

← Các kỳ thi

Mã chứng chỉ: 9203

Tài liệu in, bài tập và slide

Các tài liệu chủ đề chia sẻ giữ nguyên tên khóa học và chủ đề nguồn gốc. Sử dụng quy chuẩn của hội đồng bạn đã chọn để xác định phạm vi, cấp độ và yêu cầu kỳ thi.

Tài liệu hướng dẫn · OxfordAQA · International GCSE · Physics (8)
Phiếu bài tập · OxfordAQA · International GCSE · Physics (16)
Slide thuyết trình · OxfordAQA · International GCSE · Physics (8)
Slide hướng dẫn làm bài tập · OxfordAQA · International GCSE · Physics (16)
Hướng dẫn giảng dạy · OxfordAQA · International GCSE · Physics (1)
Tài liệu hướng dẫn · Vật lý IGCSE (6)
Phiếu bài tập · Vật lý IGCSE (24)
Slide thuyết trình · Vật lý IGCSE (6)
Slide hướng dẫn làm bài tập · Vật lý IGCSE (47)

Đơn vị học phần và mục tiêu học tập

Các bài học này dạy các mục tiêu chương trình đã chọn. Hãy kiểm tra các lỗ hổng bao phủ còn sót lại; tài liệu này không phải là chương trình chuẩn bị hoàn chỉnh.

3.1 · Lực và tác dụng của lực
  • Rate of change of displacement.
  • The gradient of a displacement-time graph is velocity. The area under a velocity-time graph gives displacement. A constant-acceleration formula is valid only when its assumption is justified.
  • Choose a positive direction and state it. Use a light gate or video with a known scale and frame interval for repeatable motion measurements. Avoid assuming hand timing is exact over very short intervals.
  • Mass multiplied by velocity.
  • Impulse equals momentum change. Increasing stopping time for the same momentum change reduces average force. Identify external forces before applying momentum conservation.
  • Draw a free-body diagram containing only forces on the selected object. For spring measurements, add loads in steps within the elastic range and measure extension from the unloaded position.
vận tốc
Tốc độ thay đổi của độ dịch chuyển
gia tốc
Tốc độ biến thiên của vận tốc.
động lượng
Khối lượng nhân với vận tốc
lực hợp
Tổng vectơ của các lực tác dụng lên một vật.
3.2 · Năng lượng
  • Energy transferred per unit time.
  • Define the system and useful output before calculating efficiency. Doubling speed quadruples kinetic energy at constant mass. Power describes transfer per time, not total energy.
  • Measure a lifting height and load, time the lift, and record electrical input with suitable instruments. Repeat trials and account for heating or friction as transfers, not missing energy.
công suất
Năng lượng truyền theo đơn vị thời gian
đầu ra hữu ích chia cho đầu vào tổng cộng
Công dụng hữu ích chia cho tổng đầu vào
3.3 · Sóng
  • Distance between successive points in phase.
  • At a boundary, frequency stays fixed by the source. A change of speed changes wavelength. Refraction follows from speed differences; angles are measured from the normal.
  • Measure several wavelengths and divide to reduce fractional reading uncertainty. Use a ray box with a normal drawn at the boundary. Keep the beam away from eyes and record incident and refracted angles clearly.
bước sóng
Khoảng cách giữa các điểm liên tiếp cùng pha
tần số
Số dao động trong một đơn vị thời gian.
3.4 · Mô hình hạt của vật chất
  • Energy per mass per temperature rise.
  • Temperature relates to particle motion in a model; internal energy includes kinetic and potential contributions. During a change of state, energy can change particle arrangements rather than temperature.
  • Measure mass, electrical input and temperature change for an insulated block. Ensure the temperature sensor has good contact, allow time for equilibration, and consider energy transferred to the surroundings.
  • Temperature on the kelvin scale.
  • State which quantities stay fixed. A pressure-volume relation requires consistent units and a fixed temperature. The kelvin-based temperature ratio is an extension only where the course explicitly specifies it.
  • Use approved apparatus with a temperature range and pressure limit set by the teacher. Allow thermal equilibrium and record pressure against kelvin temperature. Never heat an improvised sealed vessel.
nhiệt dung riêng
Năng lượng trên mỗi khối lượng trên mỗi độ tăng nhiệt độ
nhiệt ẩn
Năng lượng liên quan đến sự chuyển trạng thái
nhiệt độ tuyệt đối
Nhiệt độ trên thang đo Kelvin
chất khí lý tưởng
Mô hình khí với các giả thiết đơn giản hóa được quy định
3.5 · Điện từ học
  • Rate of flow of charge.
  • Current is the same through components in series. Potential differences add around the series path. In parallel, branches share the same potential difference, while branch currents sum at a junction.
  • Place an ammeter in series and a voltmeter in parallel. For an I-V investigation, change voltage in steps, reverse polarity when appropriate and limit current to reduce heating.
  • Creation of emf by changing flux linkage.
  • Changing field strength, coil area, orientation or relative motion can change flux linkage. Lenz law describes an induced effect opposing the change producing it, consistent with energy conservation.
  • Use a coil and sensitive meter to compare magnet motion in each direction. Record that a stationary arrangement gives no induced signal. Use approved low-voltage supplies for motor demonstrations.
dòng điện
Tốc độ dòng điện tích
hiệu điện thế
Năng lượng truyền theo mỗi đơn vị điện tích
hướng dẫn ban đầu
Sự tạo ra suất điện động do thay đổi thông lượng từ
máy biến áp
Một thiết bị truyền năng lượng giữa các cuộn dây thông qua sự thay đổi từ thông.
3.6 · Sản xuất và phân phối điện năng cùng sử dụng trong gia đình
  • Creation of emf by changing flux linkage.
  • Changing field strength, coil area, orientation or relative motion can change flux linkage. Lenz law describes an induced effect opposing the change producing it, consistent with energy conservation.
  • Use a coil and sensitive meter to compare magnet motion in each direction. Record that a stationary arrangement gives no induced signal. Use approved low-voltage supplies for motor demonstrations.
  • Rate of flow of charge.
  • Current is the same through components in series. Potential differences add around the series path. In parallel, branches share the same potential difference, while branch currents sum at a junction.
  • Place an ammeter in series and a voltmeter in parallel. For an I-V investigation, change voltage in steps, reverse polarity when appropriate and limit current to reduce heating.
hướng dẫn ban đầu
Sự tạo ra suất điện động do thay đổi thông lượng từ
máy biến áp
Một thiết bị truyền năng lượng giữa các cuộn dây thông qua sự thay đổi từ thông.
dòng điện
Tốc độ dòng điện tích
hiệu điện thế
Năng lượng truyền theo mỗi đơn vị điện tích
3.7 · Vật lý hạt nhân
  • Time for activity or undecayed population to halve.
  • Subtract background counts measured over the same time interval. Distinguish irradiation from contamination. Shielding, distance and reduced exposure time can reduce risk under a school-controlled procedure.
  • Use teacher-managed sources and the school radiation rules. Record count duration and repeat background measurements. Do not extrapolate a half-life from one nucleus or from uncorrected readings.
thời gian bán rã
Thời gian để hoạt động hoặc quần thể chưa phân rã giảm một nửa
bức xạ nền
Bức xạ đo được tách biệt khỏi nguồn đang nghiên cứu.
3.8 · Vật lý thiên văn
  • A stable stellar phase sustained by core hydrogen fusion.
  • Read a life-cycle diagram as a model of stages and conditions, not a timed film of one star. The Sun is expected to follow the lower-mass route. Fusion combines light nuclei; it differs from fission of a heavy nucleus.
  • Compare attributed stellar observations with predicted properties of each stage. Keep star, planet, galaxy and universe distinct. An orbiting body can have constant speed while its velocity changes direction.
dãy chính
Giai đoạn ổn định của sao được duy trì bởi phản ứng tổng hợp hạt nhân hydro trong lõi
sao lùn trắng
Vật dư compact trên lộ trình của sao khối lượng thấp

Chuẩn bị cho kỳ thi này

  • 9203 separate Physics; do not relabel AQA 8463 or Cambridge 0625.
  • Two untiered papers, each 90 marks and 1 h 30 min, each worth 50%; both can assess all content.
  • Practical skills are assessed in writing; retain P labels distinguishing separate Physics.

Vẫn cần bổ sung nội dung giảng dạy

  • All P-labelled separate-Physics statements including terminal velocity, centre of mass and moments remain.
  • Complete resources and energy transfer objectives remain.
  • Full sound, ultrasound, refraction/TIR and lens P statements remain.
  • Use IGCSE gas variant; complete kinetic theory and energy changes remain.
  • Full circuit, magnet and electromagnetic statements remain.
  • Separate-Physics generator/transmission P statements and all household safety remain.
  • Complete nuclear models, radiation, fission and P fusion statements remain.
  • Full star-life-cycle and cosmology statements remain.

Quy chuẩn và tài liệu mẫu

Tài liệu khóa học

Chuẩn bị khóa học

Tài liệu có sẵn. Ghi chú theo từng hội đồng, bài đánh giá và luyện tập đề thi quá khứ tương tác chưa khả dụng cho tất cả các môn học.

Bài học →

Đăng nhập hoặc tạo tài khoản

IGCSE, A-Level & AP