Current, potential difference and resistance
Introduced| English | Meaning |
|---|---|
| current/ˈkʌrənt/ | The rate of flow of electric charge. |
| potential difference/pəˈtenʃl ˈdɪfrəns/ | The energy transferred per unit charge between two points. |
| resistance/rɪˈzɪstəns/ | The ratio of potential difference to electric current. |
| charge/tʃɑːdʒ/ | An electrical property that causes attraction or repulsion. |
| ammeter/ˈæmiːtə/ | An instrument connected in series to measure electric current. |
| series/ˈsɪəriːz/ | An arrangement in which components lie along a single electrical path. |
| voltmeter/ˈvəʊltmiːtə/ | An instrument connected across two points to measure their potential difference. |
| parallel/ˈpærəlel/ | An electrical arrangement in which components are connected across the same two points and have the same potential difference. |
| ohmic conductor/ˈəʊmɪk kənˈdʌktə/ | A conductor whose current is proportional to the potential difference at constant temperature. |
| diode/ˈdaɪəʊd/ | An electronic component that allows current to flow much more readily in one direction than in the other. |
Ohm's rule, 1827
- In 1827 the German schoolteacher Georg Ohm published experiments with wires of different lengths. He found that the current in a wire is proportional to the "push" across it — and was mocked by other scientists for years.
- Today his result is in every phone charger and fuse. This lesson builds the three ideas behind it: current 电流, potential difference 电势差 and resistance 电阻.
Charge, current and potential difference
- Current is the rate of flow of charge 电荷: $Q = It$. A current of 2 A carries 2 coulombs past a point every second.
- Potential difference is the energy transferred per coulomb: $V = \dfrac{E}{Q}$. A 12 V battery gives each coulomb 12 J.
A current of 0.50 A flows for 2 minutes. How much charge passes?
Difficulty 2/5 · 140 coins + a small bonus on first completion today
$Q = It = 0.50 \times 120 = 60$ C. Change minutes to seconds.
Measuring resistance
- Put an ammeter 电流表 in series to measure the current, and a voltmeter 电压表 in parallel across the component to measure its potential difference.
- Resistance is $R = \dfrac{V}{I}$, in ohms (Ω). Vary the supply, take several pairs of readings and plot $I$ against $V$.
How should a voltmeter be connected to measure the p.d. across a lamp?
Difficulty 1/5 · 100 coins + a small bonus on first completion today
A voltmeter compares the energy per charge on the two sides of the lamp, so it goes across it.
A resistor has 6.0 V across it and 0.30 A through it. What is its resistance?
Difficulty 2/5 · 140 coins + a small bonus on first completion today
$R = \dfrac{V}{I} = \dfrac{6.0}{0.30} = 20$ Ω.
Worked example: two resistors in series
A 4.0 Ω and a 2.0 Ω resistor are in series with a 12 V supply. Find the current, the potential difference across the 4.0 Ω resistor and its power.
- Total resistance: in series, $R = 4.0 + 2.0 = 6.0$ Ω.
- Current: $I = \dfrac{V}{R} = \dfrac{12}{6.0} = 2.0$ A — the same at every point in the loop.
- Across 4.0 Ω: $V = IR = 2.0 \times 4.0 = 8.0$ V (the other 4.0 V is across the 2.0 Ω). Power $P = IV = 2.0 \times 8.0 = 16$ W.
One operating point: voltage, current and resistance
$I=\frac{V}{R};\quad P=VI$
At the worked operating point, 6 V across 20 ohms produces 0.30 A and 1.8 W.
A 9.0 V battery is connected to a 10 Ω and a 20 Ω resistor in series. What is the p.d. across the 20 Ω resistor?
Difficulty 2/5 · 140 coins + a small bonus on first completion today
$I = \dfrac{9.0}{30} = 0.30$ A, so $V = 0.30 \times 20 = 6.0$ V.
I–V characteristics
- An ohmic conductor 欧姆导体, such as a resistor at constant temperature, gives a straight line through the origin: $I \propto V$.
- A filament lamp's line curves because the hot filament has more resistance. A diode 二极管 lets current flow in one direction only. A thermistor's resistance falls as it warms; an LDR's falls in bright light.
Match each I–V graph to its component.
Difficulty 2/5 · 140 coins + a small bonus on first completion today
The shape shows how the resistance changes.
Series and parallel
- Series 串联: one path, the same current everywhere, and the potential differences add up to the supply.
- Parallel 并联: each branch gets the full supply p.d., and the branch currents add up. Adding a branch lowers the total resistance — two 6 Ω resistors in parallel give 3 Ω.
Two 12 Ω resistors are connected in parallel. What is their combined resistance?
Difficulty 2/5 · 140 coins + a small bonus on first completion today
$\dfrac{1}{R} = \dfrac{1}{12} + \dfrac{1}{12} = \dfrac{1}{6}$, so 6 Ω — less than either one.
"Current is used up by each lamp" is wrong. The ammeter reads the same before and after a lamp in series. What the lamp takes is energy: each coulomb arrives with more energy than it leaves with, and that difference is the potential difference.
In a series circuit, the current is smaller after it has passed through a lamp.
Difficulty 1/5 · 100 coins + a small bonus on first completion today
Charge is not used up, so the current is the same everywhere in a series loop.
Current is the flow of charge, potential difference is the energy per charge, and $V = IR$ links them. In series the current is shared by everything and the p.d. is split; in parallel the p.d. is shared and the current is split. Power is $P = IV = I^2R$.
A second lamp is added in parallel with a lamp connected to a battery. Explain what happens to the first lamp's brightness and to the current from the battery.
Use the parallel rules, not "the current is shared out".