Moments, equilibrium and centres of mass
Introduced| English | Meaning |
|---|---|
| moment/ˈməʊmənt/ | The turning effect of a force about a pivot. |
"Give me a place to stand", about 240 BC
- The Greek mathematician Archimedes was the first to state the law of the lever: weights balance when their distances from the pivot are in inverse ratio to the weights. Plutarch reports him saying, "Give me a place to stand and I will move the Earth." Every seesaw, spanner and crane uses the same law.
- The moment 力矩 of a force about a point is the force times its perpendicular distance from that point; it measures turning.
Calculating a moment
- Moment $=$ force $\times$ perpendicular distance, in newton metres (N m).
- A 20 N force 0.3 m from a nut gives $6$ N m. Doubling the spanner length doubles the moment.
A 35 N force acts at right angles to a spanner, 0.2 m from the nut. Find the moment.
Difficulty 2/5 · 140 coins + a small bonus on first completion today
$35 \times 0.2$.
Equilibrium
- A rigid body is in equilibrium when the resultant force is zero and the total moment about any point is zero.
- So: forces up = forces down, and clockwise moments = anticlockwise moments.
Moments, equilibrium and centres of mass
For equilibrium, both the resultant force and resultant moment are zero
Distinguish the force from its moment about a chosen pivot.
A 300 N child sits 2 m from the pivot of a seesaw. How far on the other side must a 400 N adult sit to balance?
Difficulty 2/5 · 140 coins + a small bonus on first completion today
$600 = 400d$.
Worked example: a beam on two supports
A uniform plank of length 4 m and weight 100 N rests on supports at its ends, $A$ and $B$. A 60 N child sits 1 m from $B$. Find both reactions.
- Moments about $A$ (removes $R_A$): $100 \times 2 + 60 \times 3 = 4R_B$, so $R_B = 95$ N.
- Vertical forces: $R_A + 95 = 160$, so $R_A = 65$ N.
- Check about $B$: $4 \times 65 = 100 \times 2 + 60 \times 1 = 260$ ✓.
A uniform 6 m beam of weight 120 N rests on supports at each end. A 90 N load is 2 m from the left end. Find the reaction at the right end.
Difficulty 2/5 · 140 coins + a small bonus on first completion today
About left: $120 \times 3 + 90 \times 2 = 6R$, so $R = 90$.
In the same beam, find the reaction at the left end.
Difficulty 2/5 · 140 coins + a small bonus on first completion today
$210 - 90$.
Uniform rods and centres of mass
- A uniform rod has its weight acting at its midpoint; a non-uniform rod's centre of mass is given or must be found.
- Take moments about a point where an unknown force acts, so that force drops out.
Where does the weight of a uniform rod act?
Difficulty 1/5 · 100 coins + a small bonus on first completion today
Uniform means evenly spread mass.
About to tilt
- When a beam is on the point of turning about one support, the reaction at the other support is zero.
- Set that reaction to 0 and take moments about the tilting support to find the limit.
When a plank is about to tip about support $B$, the reaction at the other support $A$ is zero.
Difficulty 1/5 · 100 coins + a small bonus on first completion today
The plank is just leaving $A$.
Use the perpendicular distance, not the length along the beam. If a force acts at an angle $\theta$ to a rod at distance $d$, its moment is $Fd\sin\theta$. And never treat the reactions as equal unless the setup is symmetric.
Moment = force × perpendicular distance (N m). In equilibrium, resultant force = 0 and total moment = 0 about any point. Take moments about an unknown force's point, use the midpoint for a uniform rod, and set a reaction to zero when on the point of tilting.
A uniform rod $AB$, 5 m long and of weight 80 N, rests on supports at $C$ and $D$, 1 m from $A$ and 1 m from $B$. How heavy a load can hang from $B$ before the rod tips?
The tilting condition.