Separate insoluble solids and recover dissolved solutes
Introduit| English | Sens |
|---|---|
| mixture/ˈmɪkstʃə/ | A combination of substances that are not chemically bonded together in fixed proportions. |
| insoluble/ɪnˈsɒljuːbl/ | Not able to dissolve in a liquid. |
| residue/ˈresɪdjuː/ | residue : résidu |
| filtrate/ˈfɪltreɪt/ | filtrate : filtrat |
Salt from the sea
- Sea salt is made by letting seawater evaporate in shallow pans under the sun. Salt crystals are left behind.
- Rock salt dug from mines contains sand and clay as well, so it needs two steps: dissolve and filter, then evaporate.
- A mixture contains substances that are not chemically joined, so it can be separated by physical methods.
Filtration
- Filtration separates an insoluble solid from a liquid. The solid stays on the filter paper as the residue 滤渣.
- The liquid that passes through is the filtrate 滤液. Dissolved salt is in the filtrate — its particles are far smaller than the holes in the paper.
Sand and salt water are filtered. Match each part.
Difficulté 2/5 · 140 pièces + un petit bonus lors de la première réussite aujourd'hui
Insoluble solids stay; solutions pass.
Crystallisation
- Heat the filtrate gently to evaporate some water until crystals start to form at the edge.
- Leave it to cool: more crystals form. Filter them off and dry them.
- Do not boil it dry — this can make the crystals spit and can break down some salts.
Put the steps to get pure salt from rock salt in order.
Difficulté 3/5 · 200 pièces + un petit bonus lors de la première réussite aujourd'hui
Dissolve, filter, crystallise.
Why should the solution not be boiled dry?
Difficulté 1/5 · 100 pièces + un petit bonus lors de la première réussite aujourd'hui
Gentle evaporation and cooling give better crystals.
Worked example: percentage recovered
A mixture contains 6.0 g of sand and 10.0 g of salt. After separation, 5.4 g of sand and 8.0 g of salt are recovered.
- Sand: $\dfrac{5.4}{6.0} \times 100 = 90\%$.
- Salt: $\dfrac{8.0}{10.0} \times 100 = 80\%$.
- The missing mass was not destroyed: some stayed on equipment, some salt stayed dissolved, and some sand was lost in transfers.
Percentage recovery of sand and salt
From 6.0 g sand and 10.0 g salt, 5.4 g and 8.0 g are recovered: 5.4 ÷ 6.0 × 100 = 90% and 8.0 ÷ 10.0 × 100 = 80%. Mass not recovered was lost in transfers or left in solution, not destroyed.
12.5 g of salt was in a mixture and 10.0 g was recovered. What percentage was recovered?
Difficulté 2/5 · 140 pièces + un petit bonus lors de la première réussite aujourd'hui
$\dfrac{10.0}{12.5} \times 100 = 80\%$.
Improving purity
- Wash the sand residue with a little water to remove salt solution stuck to it.
- Wash crystals with a small amount of cold water: it removes surface impurities but dissolves little salt.
Why are crystals washed with a small amount of COLD water?
Difficulté 1/5 · 100 pièces + un petit bonus lors de la première réussite aujourd'hui
Cold water dissolves less salt.
Filtration cannot separate a dissolved solid. Salt solution passes straight through filter paper. You must evaporate or crystallise to get the salt back.
Filtration can separate dissolved copper sulfate from water.
Difficulté 1/5 · 100 pièces + un petit bonus lors de la première réussite aujourd'hui
Dissolved particles pass through filter paper.
A mixture can be separated by physical methods. Filtration removes an insoluble solid (residue) from a liquid (filtrate). Crystallisation recovers a dissolved solid by evaporating some solvent and cooling. Mass not recovered was lost in handling, not destroyed.
Describe how to obtain dry samples of both sand and salt from a mixture of the two.
Two physical methods are needed.