Skip to content

IGCSE Physics · November 2022 · Paper 52 · Difficulty 3 · Standard

Question 3

3

In this experiment, you will investigate the balancing of a metre rule.

Carry out the following instructions, referring to Fig. 3.1.

(a)

Place the metre rule on the pivot, with its scale facing upwards, so that the metre rule is as near as possible to being balanced. Record the scale reading S on the metre rule at the point where the rule balances on the pivot.

S = cm[1]

(b)

• Place object Q with its centre on the metre rule at the 90.0 cm mark.

  • Place a load P of weight P = 1.0 N on the metre rule.
(i)

Adjust the position of the load P so that the metre rule is as near as possible to being balanced. The pivot must remain directly below the scale reading S.

Measure, and record in Table 3.1, the distance a from the centre of load P to the centre of load Q, as shown in Fig. 3.2.[1]

(ii)

Repeat the steps above, using loads of weight P = 2.0 N, 3.0 N, 4.0 N and 5.0 N.

Record all the values of a in Table 3.1.

Table 3.1

P/Na/cm1/P / 1/N
1.01.00
2.00.50
3.00.33
4.00.25
5.00.20

[3]

(c)

Plot a graph of a/cm (y-axis) against 1/P / 1/N (x-axis). Start the y-axis at a/cm = 30. Start the x-axis at 0.

[4]

(d)

Record the value of a when 1/P = 0. Show clearly on the graph how you obtained the necessary information.

a = [2]

[Total: 11]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

3(a)

  • Balance the rule on the pivot and read its scale at the pivot to the nearest millimetre.
  • A typical value is $S = \mathbf{50.0}\,\mathrm{cm}$, but use the balance point you measure.

3(b)(i)

  • Keep the pivot at $S$ and move $P$ until the rule balances. Measure from the centre of $P$ to the centre of $Q$.
  • Record your measured distance $a$ in $\mathrm{cm}$, to the nearest $0.1\,\mathrm{cm}$.

3(b)(ii)

  • For each load, balance the rule again and measure $a$ between the centres of $P$ and $Q$.
  • Record all five distances in $\mathrm{cm}$ to the nearest $0.1\,\mathrm{cm}$. They should decrease as $P$ increases and each should be greater than $45.0\,\mathrm{cm}$.

3(c)

  • Label the horizontal axis $1/P$ in $1/\mathrm{N}$ and the vertical axis $a$ in $\mathrm{cm}$. Start them at $0$ and $30\,\mathrm{cm}$ respectively.
  • Choose scales that use the grid well. Plot each measured point within half a small square.
  • Draw a thin, continuous best-fit line through the trend of the points.

3(d)

  • Extend your best-fit line to $1/P = 0$ and show the intercept on the graph.
  • Read $a$ at that intercept to within half a small square and give it in $\mathrm{cm}$. The value depends on your measured graph.
Original question

Log in or create account

IGCSE, A-Level & AP