Skip to content

IGCSE Physics · June 2023 · Paper 51 · Difficulty 3 · Standard

Question 3

3

In this experiment, you will investigate the refraction of light using a semicircular transparent block.

Carry out the following instructions using the separate ray-trace sheet provided. You may refer to Fig. 3.1 and Fig. 3.2 for guidance.

(a)

• Draw a line across the ray-trace sheet supplied, approximately in the middle. Label the line PQ.

  • Place the transparent block, largest face down, with the straight side on the line PQ and the curved side below the line.
  • Draw round the outline of the block. Label the ends of the straight side of the block A and B.
  • Remove the block and draw the normal NL through the centre of AB. Continue the normal so that it passes through the curved side of the block.
  • Label the point C where the normal NL crosses AB. [1]

(b)

• Draw the line DC at an angle $i = 30^{\circ}$ to the normal, as shown in Fig. 3.1.

  • Place the paper on the pin board.
  • Place two pins, $P_1$ and $P_2$, on line DC at a suitable distance apart for this experiment.
  • Replace the block and look from the position of the eye shown in Fig. 3.1 to observe the images of $P_1$ and $P_2$ through side AB of the block. Adjust your line of sight until the images of $P_1$ and $P_2$ appear one behind the other.
  • Place two pins, $P_3$ and $P_4$, between your eye and the block so that $P_3$, $P_4$, and the images of $P_1$ and $P_2$ seen through the block, appear one behind the other.
  • Label the positions of $P_1$, $P_2$, $P_3$ and $P_4$.
  • Remove the block and the pins.
  • Draw a line joining the positions of $P_3$ and $P_4$. Continue the line to AB.
  • Label E, the end of the line furthest from AB. [3]

(c)

Measure the acute angle $\theta$ between the line NL and the line CE. (An acute angle is less than $90^{\circ}$.)

$\theta$ = °[2]

(d)

State one precaution that you take to produce an accurate ray trace.[1]

(e)

Place the transparent block on the ray-trace sheet in the position shown in Fig. 3.2.

  • Replace pins $P_1$ and $P_2$ on line DC in the same positions used in (b).
  • Observe the images of $P_1$ and $P_2$ through the curved side of the block. Adjust your line of sight until the images of $P_1$ and $P_2$ appear one behind the other.
  • Place two pins, $P_5$ and $P_6$, between your eye and the block so that $P_5$, $P_6$, and the images of $P_1$ and $P_2$ seen through the block, appear one behind the other.
  • Label the positions of $P_5$ and $P_6$.
  • Remove the block and the pins.
  • Draw a line joining the positions of $P_5$ and $P_6$. Continue the line to AB.
  • Label F, the end of the line furthest from AB. [2]

(f)

Measure the acute angle $\theta$ between the line NL and the line CF. (An acute angle is less than $90^{\circ}$.)

$\theta$ = °[2]

[Total: 11]

Tie your ray-trace sheet into this question booklet between pages 8 and 9.

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

3(a)

  • Draw NL through the centre of AB, at $90^\circ$ to AB. This makes NL the normal.

3(b)

  • Draw DC at $30^\circ$ to the normal and place P1 and P2 at least $5.0\,\mathrm{cm}$ apart.
  • Line up P3 and P4 with the images of P1 and P2. Join P3 to P4 and extend the line to AB, then label its far end E.

3(c)

  • Place the centre of a protractor at C and measure the acute angle between NL and your line CE.
  • Record your measured angle to the nearest degree. It should be greater than $\mathbf{30}^\circ$, because the ray bends away from the normal as it leaves the block.

3(d)

  • Keep the pins vertical so their positions can be lined up accurately.

3(e)

  • Line up P5 and P6 with the images of P1 and P2, then join their positions and extend the line to AB.
  • The line should meet AB at C, with F above AB and to the right of the normal.

3(f)

  • Place the centre of a protractor at C and measure the acute angle between NL and your line CF.
  • Record your measured angle to the nearest degree. It should be less than $\mathbf{30}^\circ$, because the ray bends towards the normal as it enters the block.
Original question

Log in or create account

IGCSE, A-Level & AP