Skip to content

IGCSE Physics · June 2020 · Paper 62 · Difficulty 4 · Challenging

Question 4

4

A student investigates the bending of 1 m length strips of different materials. She compares how far they bend when loaded at one end.

Plan an experiment to investigate how the material from which the strips are made affects the bending of the strips when loaded at one end.

The following apparatus is available to the student:

strips of wood, plastic, steel and aluminium, each of length 1 m a set of slotted masses a metre rule a G-clamp (used to hold the strips to the laboratory bench).

Other apparatus normally available in a school laboratory can also be used.

In your plan, you should:

• draw a diagram to show the arrangement of the apparatus

• explain briefly how you would carry out the investigation, including the measurements you would take

• state the key variables to be kept constant

• draw a suitable table, with column headings, to show how you would display your readings (you are not required to enter any readings in the table)

• explain how you would use the results to reach a conclusion.[7]

[Total: 7]

Show the mark scheme

These are the official mark-scheme rows. Each point that matches your answer earns a mark.

Tap the mark scheme to open it full size.

Show a worked answer

How to reach each mark, step by step. Try the question yourself first.

  • Draw a strip clamped to a bench with most of it overhanging. Hang a load at its free end and place a vertical metre rule beside that end.
  • Measure the end height before and after loading. Depression = unloaded height minus loaded height. Repeat for each material with the same load, overhang, width and thickness.
  • Make a table headed material, load mass / g and depression / cm. Record the results in it.
  • Compare the depressions for the same load. The strip with the largest depression is the most bendy.
Original question

Log in or create account

IGCSE, A-Level & AP